|02-10-2013 10:44 PM|
|IcarusLSC||No problem, I hope you get them back together.|
|02-10-2013 04:32 PM|
|02-10-2013 03:42 PM|
|IcarusLSC||Here, they should go like this: the black tabs from the bulb piece should go inside the tab and inside the light body. Then the bulb holder ring goes on the outside as I mentioned between the light housing and the screw washer:|
|02-10-2013 03:24 PM|
When you take the screws out, you shouldn't have taken them right out. They are tabs that should stay in there and hold and pull the lens inwards when tightened.
Put them back in loosely with the screws, you should hopfeully see how it works then if you put the tabs up close to it. Then the bulb holder ring goes over the outside between the plastic washers on the screws and the housing...
I'll attach a pic of the 520's I have, the clips are similar...
|02-10-2013 03:11 PM|
|02-10-2013 02:36 PM|
|easley15||I need help!!|
|02-10-2013 02:24 PM|
|easley15||These are it|
|02-10-2013 02:21 PM|
Piaa lights question
So I opened the light and these two tabs fell down and I can't seem to figure out how to get then to stay in to put it back on