Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > hard top question

Join Wrangler Forum Today


Thread: hard top question Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
03-22-2013 03:20 PM
Hatch This hardtop manufacturer is in CA and I thought uses a similar system.

Wild Boar Products
Huntington Beach, CA 92649
Phone: 714-840-3399
Fax: 714-840-6267
Contact: Deborah Duncan
Sales | Installation
03-21-2013 03:44 PM
djjd76 Anybody? help?
03-15-2013 05:52 AM
djjd76 Not sure of the brand or where to look to find out. The only sticker on it is in the rear window and it says California Hard Tops.
03-15-2013 02:02 AM
Neil F. What brand is it? Bestop/Keystone, Steelhorse (out of buisness) and there is one other, either Rallytop or Bulldawg
03-14-2013 03:45 PM
djjd76
hard top question

I have a two piece hard top. There are locking pins that slide up through a whole in the hard top that are supposed to be there to hold the top in place while you lock the clamps down on the roll bars. They are located just behind the doors at about eye level. The one on the passenger side has been either busted, or sheard off at some point, so that when you lock it down, the front part of the top gets pulled toward the windshield. This of course causes a lot of problems, from excessive noise to leaking.
I'm thinking I might be able to drill it out, and retap the whole to thread a bolt up through to replace the original pin.
Any thoughts better than this one lol?
I can't find replacement pins for this thing anywhere. Been looking online for days.
Any help at all is much appreciated. Thanks in advance.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 10:27 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC