|04-06-2013 11:20 AM|
I ordered this hose.
GM Parts Direct: 15131046 - HOSE
And followed this video.
Jeep Wrangler Fuel Overflow Repair - YouTube
It takes a little cutting of the new hose but it has worked like a charm so far.
|04-06-2013 06:55 AM|
|mdutton||Jwolfer where did you find a longer filler neck hose? I had to slide mine partially off each side to make it long enough. The fuel burp has happen to me in the past when tank reaches full|
|04-02-2013 04:10 PM|
|04-02-2013 02:05 PM|
|WVU Mountainman||Will I have any issues with my auto transmission shifter|
|04-02-2013 12:49 PM|
|NC Bear||I did not have to extend anything. I did have to replace my shift boot with one of the "pleather" ones from Autozone.... I kept popping off the accordion type boot especially on the colder mornings|
|04-02-2013 12:43 PM|
Didn't need to extend the brake or fuel lines. Grease the Radiator support snubbers to ease with install. I removed the headlights and pulled the nipple through with pliers. Some have had luck lowering the tub down for the snubbers to pop in place. Only do one side at a time to prevent the tub from shifting and remember to undo the fuel filler bolts before jacking up the Jeep.
|04-02-2013 11:54 AM|
Brake lines will be fine. The fuel neck "should be" fine. If you have a manual tranny with rubber accordian shift boot, expect it make 2nd & 4th gear hard to get into. Yank the boot off and replace it with a $10 pleather shifter boot from Autozone.
Since you already have the MML installed, your radiator shroud is probably adjusted for the MML...you will probably have to adjust it again for the BL so your fan doesn't hit.
|04-02-2013 11:51 AM|
|Jwolfer||The BL was very easy to install, especially with socket extensions. The MML on the other hand was a pretty big pain but that's only because I have a late model TJ with the AC compressor too close to the driver side mount. My brake lines are fine but my filler hose is too short. I should be getting a new hose in the mail today that will be longer and will also solve my gas spit back issue so I am killing two birds with one stone.|
|04-02-2013 11:43 AM|
JKS 1.25 BL pre purchase questions
I have a 2" suspension lift and 1" MML and am looking to install the JkS 1.25 BL.
Will I have to extend brake lines or gas filler hose?
Any other helpful tips for installing? Any drawbacks to this BL?