|04-03-2013 07:48 PM|
Try the Socket - That was my issue (not the bulb or wiring - the sockets come out pretty easy and you can buy another or just use a small screw driver to adjust / pry)
Also not just the back socket but the front also since it is has a running ground (the ground runs through the front to the back etc). Mine was the front Drivers that was causing issues for the rear drivers - talk about annoying to figure out.
|04-03-2013 07:14 PM|
pull the blub, look inside the plug to see if there is some corrosision going on.
get a little wire brush in there to clean things up. try it again.
|04-03-2013 07:06 PM|
|04-03-2013 07:00 PM|
|Wheel2Work||It's a dual filament bulb, so the marker light filament can break and not affect turn signal or brake light. Chances are real high it is simply a bad bulb.|
|04-03-2013 06:11 PM|
Right tail light out, sorta
My right tail light is out but my brake light and turn signal still work and they run of the same bulb which is strange, I changed the bulb and checked the fuses and it all checks out but still no tail light. Any and every suggestion would help.