|04-14-2013 07:53 PM|
A MML will slightly help with driveline angles as it lifts the front of the motor, and causes you tailshaft to tilt down slightly. Will it be enough to not need a SYE/CV shaft or a TC drop? It all depends on your Jeep and what lift you are running. For my Jeep, I had a slight driveline vibe after installing a 2.25" BB as my first lift, the MML cured it.
|04-13-2013 08:59 PM|
|mr_bungle||i have a couple of questions about the body lift and the mml . if you have the mml and the body lift do you still need the extension brackets for the transmission and /or the transfer case ? and if you have a suspension lift how does the mml effect the geometry of the drive line?|
|04-11-2013 10:30 AM|
I would normally say do the BL first. An extra inch of room under there wouldn't hurt the mml install. That is what I did.
But, since you are swapping a 3" for a 1" BL, do the mml first.
|04-11-2013 10:11 AM|
|1ofakind||Well I got the new bl in last night I didnt have time to do the mml ill finish it up tonight after work. Ended up having problems with the last body mount on the back just above the bumper. The bolt just spins so im not sure what I can do about this|
|04-10-2013 11:08 PM|
|Patrick H||I did the BL first, although it doesn't really matter. Took about 2 1/2 hours to do both.|
|04-10-2013 10:44 PM|
I did BL and then MML, using the JKS parts. In your case, I would remove the fan shroud hardware and the transfer case linkage, then do the MML, taking advantage of the 3" of space in the old BL. Then I would reduce the BL to 1.25", then I would reinstall fan shroud and TC shift linkage.
Before you start, back off on the transfer case skid bolts a couple of turns so the skid can move around. Your last step would be to tighten those bolts.
|04-10-2013 10:27 PM|
|1320quick||I installed both a body lift and MML on my TJ last week. I installed the body lift one day and then installed the MML a couple of days later. That seemed to work fine for me.|
|04-10-2013 10:13 PM|
|Dextreme||I would plan to install them both in the same day. Takes just a few hours to do the MML.|
|04-10-2013 09:41 PM|
|1ofakind||Well im completely replacing the 3" with the 1.25 and I got the 1" mml so I dont have to move fan shroud ect|
|04-10-2013 08:54 PM|
|kshaws21||So are you planning on adding the 1.25 bl to the already 3" body lift? If so, wow. If not and you are replacing the 3 with the 1.25, then you wouldn't need the mml lift at all.|
|04-10-2013 08:40 PM|
mml or bl install first
What should I install first. I received my mml and bl today from quadratec quick 3 day shipping and im in alberta canada. But anyways I have a 3" body lift right now what should I do first 1" mml or 1.25 bl? Thanks ill be starting the install in about an hour