Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > General Jeep Discussions > Communications and Electronics > Amp getting no power

Join Wrangler Forum Today

Thread: Amp getting no power Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-14-2013 06:15 PM
JayJitsu Yup, fuse powered line. It makes sense that the fuse would be blown especially after testing it with the multimeter
04-14-2013 06:06 PM
woansleftpeg I presume you have used a fused power line from the battery to the amp? I would be very surprised if it was anything other than a blown fuse there.

Remember, when you do these installs you should keep the fuse out until everything is connected up, then put your fuse in last of all to complete the job prior to testing.
04-14-2013 05:14 PM
Amp getting no power

Hey guys, I fixed my problem with my head unit thanks to your guys, so I'm hoping you can help me out one last time. After hooking up my amp and trying it out, I realized it wasn't getting any power. I have so many ideas of what could be wrong so I'm thinking the easiest way to figure this out would be to just going to tell how I hooked it up and the trouble shooting I've done so far and let you guys critique it.

After getting my head unit running good, I installed my new speakers and then started on the amp. I hooked up the ground first because it seemed like the easiest to do. After that I hooked up the power to the battery. when I attached it, It sparked a bit. I assumed that just meant i had a good ground and all was well. After that, i attached the constant 12V from the back plug of the head unit to the amp. Lastly, I attached the speaker wires to of the speakers (I only attached it to one because i wanted to test if it worked before I went further). After all that, I fired it up and no power. So, my first thought was maybe the ground was bad, so I moved it around to three or four spots and still nothing. Then I decided to test the power. I broke out the multimeter and attached it to the power line coming from the battery and a ground. Nothing.

What could be the problem here? When I used the multimeter, I didn't even use the wire for the ground, just the multimeter itself to ground. So that means the only problem could be coming from the battery power. Could I have blown a fuse or something when it sparked?

Any ideas would be greatly appreciated!

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 09:07 AM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC