|04-25-2013 01:02 PM|
|hatmaker||Well turns out that the transmission mount has gone out|
|04-17-2013 06:46 PM|
|hatmaker||Ok i did an inspection today on my trans lines and 4wd shifter and everything looks good and feels tight and i did have one tran line popped out of its clip and u popped it back in but i still have this knocking, u dont believe its the 4wd shifter linkage because it feel like its coming from the trans area|
|04-16-2013 03:35 PM|
|Water Dog||See if it will shift into 4-wheel drive. If the shifter handle doesn't have any resistance, your tc shift linkage has come apart. When it happened to me, I popped it back together only to have it come out again....turned out it was a bad tc mount (separated) allowing the transfercase to shift and pop out the linkage. Once I replaced the mount, all was good.|
|04-16-2013 03:22 PM|
|04-16-2013 12:55 PM|
|04-16-2013 11:58 AM|
|Ryman12||Try removing the rear driveshaft and driving around in 4 hi for a while. If the vibes are gone then its safe to assume the rear DS u-joints are bad or perhaps a pinion bearing. Did you install a SYE kit?|
|04-16-2013 11:51 AM|
|MuddyHell||I replaced my rear driveshaft u-joint and that stopped the drive-line vibrations for me. The steep angle the lift puts on the joints is hell|
|04-16-2013 11:51 AM|
|04-16-2013 09:57 AM|
|Rolf||I'm guessing that there is a suspect u-joint on the rear driveshaft.|
|04-16-2013 09:40 AM|
Would you happen to know where the vibration is coming from? I had something similar after I installed my lift. For me, I heard a rattle or knocking sound under my rig everytime I accelerated which would fade out in a few seconds. I also noticed when I would go over bumps quickly, the same rattle would appear.
I had a transmission line come off it's metal clip and it was taping on the frame and the acceleration knocking problem was due to my transfer case linkage after I put on the lift. I just replaced the whole linkage with a Novak shifter cable, I haven't had the problem ever since.
|04-16-2013 08:46 AM|
Vibration in driveline somewhere upon accelerating
I cant figure this one out. I put my 3 in suspension lift on bout 3 months ago and everything was fine. after about 3 weeks I had a vibration start happening when i accelerate from stop but quits almost immediately. So thinking it was just something that came loose i went back through my jeep and re torqued everything back down to spec. the same problem still occurs, i am stumped on what it could be. what do Y'all Think?