Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ Tech Forum > 1997 Jeep Wrangler Clutch Problems

Join Wrangler Forum Today


Thread: 1997 Jeep Wrangler Clutch Problems Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-01-2013 05:21 AM
All Terrain JK
Quote:
Originally Posted by kyjeep View Post
The best way I found to bleed one is to fill the reservoir and leave the cap off. Then remove the slave cylinder from the beel housing and hold the rod pointing down. Now slowly push the rod all the way in two to three times. It will push all the air back up the line and out through the clutch master cylinder. After this is done check you fluid level reinstall the slave and test it.
This method works for me as well. I will also tap the slave and tube lightly with a screwdriver handle to help dislodge stubborn air bubbles. It helps to have someone watching the master cylinder fluid level and tell you when the air bubbles stop.
04-30-2013 10:17 PM
kyjeep The best way I found to bleed one is to fill the reservoir and leave the cap off. Then remove the slave cylinder from the beel housing and hold the rod pointing down. Now slowly push the rod all the way in two to three times. It will push all the air back up the line and out through the clutch master cylinder. After this is done check you fluid level reinstall the slave and test it.
04-30-2013 07:15 PM
rbabchuk
1997 Jeep Wrangler Clutch Problems

this past weekend I decided to bleed the clutch because when it warmed up it was hard to shift into first and reverse. as I was bleeding it I was underneath the jeep while my wife pushed in the clutch. as recommended I would have her push in the clutch and hold it and I would release the hex screw to let some air/fluid out. about the third time I did this the clutch pedal got real soft and will not engage anymoer and I cannot put the car into gear when it is on. While the jeep is off I can put it into first and the jeep will jump. Does anyone have any suggestions?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 11:59 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC