|05-01-2013 08:13 PM|
|DutchmansLJ||well i dont have alot of experience in this but i would assume the shaft is broken, since its up on the lift just remove the shaft it doesnt hurt anything as long as u dont lose any parts, for me it took me 10 min to pull apart the caliper and bolts holding the shaft to the axel and it was out|
|04-30-2013 04:09 PM|
Spin the drivers side and it spins the drive shaft.
Spin the passenger side and it has a little wabble in it and clicks. When I spin this on the drive shaft doesn't move.
Neither side spins the other tire.
|04-30-2013 02:32 PM|
Jack up the rear, both tires off the ground
Trans in neutral.
Spin one rear tire forward with your hand.
Describe what happens to the other tire, and what you hear.
|04-30-2013 02:22 PM|
|FR0STY||And how bad is it to drive like this? Haha cause I really don't feel like tearing the rear end apart till this weekend.|
|04-30-2013 02:21 PM|
|FR0STY||Yes. When I hit the gas it's only spinning the drivers side. When its on a lift, The passenger side tire will move back and forth a little. And it's leaking something out of that side right where the hub is.|
|04-30-2013 01:30 PM|
|04-30-2013 12:16 PM|
|04-30-2013 12:08 PM|
|04-30-2013 11:56 AM|
Doubt its a snapped axle... wouldn't the tire be falling out then as well?
When you say its only spinning one tire, is that on the ground as well when you hit the gas?
|04-30-2013 10:47 AM|
|04-29-2013 03:33 PM|
Rear ends and axle shafts.
I don't know where this should go but here seems like a good spot.
I have a Dana 44 (I think) in the rear end and it's only spinning one tire. Lifted it up and the passenger tire spins freely with a slight clicking noise. Any idea what it is. My dad says it's the bearings but wouldn't it still spin the tire? Help please.