|05-09-2013 02:59 PM|
|Surfinglbi23||Anyone have a clue on this? Not leaking terribly, just a few large drops after a drive. Maybe 1/4 ounce of fluid on the driveway this morning. I would swap in a new axle but just swapped this one in a couple months back and was hoping to avoid doing it again lol|
|05-08-2013 09:01 PM|
Need help with pinion seal leak
95 2.5 stock Dana 35. I've been getting a leak out of the rear pinion seal.
So, first just did the seal. No better. So I thought maybe the yoke had a groove worn into it.
Did a new seal, yoke, crush sleeve, bearing. Felt a little loose on the pinion but much better. Still leaking.
Any ideas? New ring gear and pinion? Hoping to avoid if possible.
Suggestions/directions welcome ... Thanks folks