|05-20-2013 03:20 PM|
|Jrgarcia715||You guys are all lucky I get about 10mpg on a good day|
|05-20-2013 01:53 PM|
|ChicoJeepy||My tires are brand new from the early 2000's because when the state of Oregon stopped using steel studded tires and went to aluminum studs. So my set of Radial Wildcats are really nice thick walled tires and balanced. Good thing I kepted them all these years.|
|05-20-2013 01:48 PM|
|sevenservices||not engine related, but double check your tire pressure and also make sure none of the brakes are dragging. A low tire, or dragging brakes will totally kill your mpg. Even 5 pounds low can hit the mpg quite a lot.|
|05-20-2013 01:30 PM|
|Sworsen94wrangler||Wow I'm only getting 18 miles per gallon on my 94 yj|
|05-20-2013 01:22 PM|
|ChicoJeepy||Heck I think my 93 Wrangler is getting about 20-25 MPG and I'm only using 3/4 of the 20 gallon tank.|
|05-20-2013 11:52 AM|
|05-18-2013 09:10 PM|
That engine needs to be broken in!!!!....tolerances may still be a little tight.....run it on dyno oil for a while and you will see the MPG and power slightly climb....
|05-18-2013 09:04 PM|
|rkidd||I have a 84 cj7 with a 4.2l. Great motor but the carb. was junk from the factory. Switched to fuel injection. Problem solved.|
|05-18-2013 08:59 PM|
|Odie4AZ||Where did you find your new engine? I've been looking but can only find a rebuilt from Automotix..|
|05-18-2013 12:30 AM|
|05-18-2013 12:28 AM|
|05-18-2013 12:27 AM|
|05-18-2013 12:26 AM|
|05-17-2013 07:30 PM|
|TreeClimber1||How much fuel have you ran thru the new engine?|
|05-17-2013 07:24 PM|
|Nubby55||Did You use the same Carb.? adjust it with vacuum gauge and set the timing and wait for it to break in.|
|05-17-2013 03:06 PM|
Only 14.3 miles per gallon on new 4.2 L engine.
I put a new 4.2 L engine In my 1988 Jeep Sahara. And I'm only getting 14.3 miles per gallon whether I drive at 80 miles an hour or 65 miles an hour.
My old engine was getting 17 – 18 miles to gallon But it was fixing to crater.
Is there some sort of a harmonizer that you can hook up to the engine to find out If the engine or the carburetor or something is running rich .
If so what is the name of the machine I need to hook it up to.
I'm located in San Antonio Texas. Does anybody know of any shops that would handle that.