|05-20-2013 03:01 PM|
|Saranrap||awesome thanks for the links guys! ill post back prices when i get them|
|05-20-2013 01:34 PM|
|05-20-2013 10:48 AM|
|Disconnected||Been running 35's on my daily driver JK and honestly prob wheel about the same as you, 5-6 times a year on some semi-difficult trails and havnt had an issue. So long as ya dont pretend your running the hammer i imagine you'll be fine. That being said, if slapping some sleeves and gussets give ya the peace of mind then I'd go ahead and do it.|
|05-20-2013 10:41 AM|
I know at least two people on the forum have mentioned them for various work / projects they have done. Might want to seek them out and see if it is worth following up.
|05-20-2013 10:20 AM|
does anyone know of a good 4WD drive or a good welder in NJ or eastern PA that can do this. I am also down in virginia alot (around williamsburg) and could try and schedule something when im down there.
|05-19-2013 07:09 PM|
|HK_Runner||Sleeves and gussets- the kits cost maybe $200-$250. Installing/welding them will cost around another $250-$350 around here.|
|05-19-2013 05:32 PM|
|rics1997||IMO gussets are a must and sleeves are dependent on how hard you off road|
|05-19-2013 02:25 PM|
|Ex Umbris Currus||I just did the ACE C-Gussets with my 35s. Cost $63 and around $50 to get them welded on. Of course, bent Cs would have given me an excuse to buy a ProRock 60.....|
|05-19-2013 02:25 PM|
|Saranrap||thanks, im a slow and steady kind of guy when wheeling.|
|05-19-2013 02:05 PM|
Most likely you will be getting 2 opinions on this.I didn't bother when I had 35s and nothing bad happened even playing on the rocks.
It also depends how you wheel your Jeep. If your the aggresive type that powers thru stuff rather than being finesse then yes.
With the type of wheeling that you say you do I would at least get the bracket to relocate your steering damper up higher if you haven't done so.
|05-19-2013 01:46 PM|
Sleeve And Gusset required for 35's?
looking at taking the plunge and getting 35's, trying to budget for it because it requires doing alot of things to support it (lift,shocks,drive shaft,brake line extenders, rear tire carrier and bumper, etc)
Was going to order the rancho lift but started digging a bit more found posts saying i need todo this. Im not a heavy wheeler but do light to medium trails here and there (3-6 times a year, not enough i know )
Can i get away with not doing sleeves and gussets for now or am i playing with fire? i cant weld and even if i did know how to im not sure i would trust my self because its so critical.
I live in South NJ so its not like we have a bunch of wheeling shops around can anyone comment how much it roughly costs to have a good welder do this.