|05-19-2013 04:19 PM|
|cchartrand||Nice link my friend! Thanks for your time.|
|05-19-2013 04:10 PM|
|Black Magic Brakes||
Grades 5 and 8 Finished Hex Nuts
I buy and use specified grade 8 and 5 nuts on a weekly basis.
|05-19-2013 04:01 PM|
|05-19-2013 03:00 PM|
Here's a 1/2X20 I grabbed
|05-19-2013 02:52 PM|
FWIW, this is what a grade 8 nut looks like
I went out and checked the Gr.8 nut drawer in my garage, and they look like this.
|05-19-2013 02:45 PM|
|cchartrand||Thanks for the help guys!|
|05-19-2013 02:41 PM|
|05-19-2013 02:31 PM|
|05-19-2013 02:30 PM|
|cchartrand||Nice link. Unfortunately it just leads to more questions. Clearly those nuts are graded. Back to my original question... Again, none of those gradings, correlate w/ bolt gradings. Could you help me out w/ bolt Vs. nut grading?|
|05-19-2013 02:26 PM|
|05-19-2013 02:19 PM|
The nuts to be used with Grade 8 fasteners are almost always gold colored and have a digit or number stamped on one side.
Always use these nuts and washers on Grade 8 bolts.
|05-19-2013 02:05 PM|
|Wheel2Work||No such animal as a Grade 8 Nut. Check here: http://www.americanfastener.com/tech...ings_steel.asp|
|05-19-2013 01:14 PM|
|05-19-2013 12:50 PM|
|ob269||Afaik, there its no markings on the nuts or washers.. I've only seen gold finish grade 8 so they was how I always identified them..|
|05-19-2013 12:26 PM|
|05-19-2013 11:44 AM|
|Sinister6||Typically the Grade 8 nuts will have the gold finish like the grade 8 bolts assuming they don't have a coating (zinc). The benefit of the GR8 nut in my opinion is if they are located in a place you can't get socket or box wrench. A open end or crescent could round a GR5 but the hardness of the GR8 might help prevent it. If I weld a nut to something I ALWAYS use the GR8... Others may have their own opinion...|
|05-19-2013 10:56 AM|
Grade 8 NUTS
Hi guys. I have some questions on grade 8 NUTS. Notice I said NUTS. I am well aware of how to identify a grade 8 BOLT, I'm just curious about nut identification. I'm also wondering how important a grade 8 nut would be. I'm thinking a grade 5 would be fine depending on which way the shear force is applied. Thoughts?????