Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > JK Jeep Wrangler Forum > JK General Discussion Forum > 4 x 55W bulbs for rock lights - Wiring questing

Join Wrangler Forum Today


Thread: 4 x 55W bulbs for rock lights - Wiring questing Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-23-2013 09:38 PM
jkjeeper06
Quote:
Originally Posted by tlminh View Post
Correct, each wire would be 55w/12v = 4.58 A

So a 5A fuse to each light?
Not sure. Quite often the alternator actually makes the battery output about 14v. That would lower the current in the wires. HOWEVER.. When you turn on lots of lights and draw lots of power off the battery you can drop it lower. I've seen it to almost 8v with a ton running from it(guy probably needed a bigger alternator/battery combo) but that would make it at 7A and would blow your fuse. I'd almost put an 8A(do they exist?) or a 10A fuse in. 16ga can hold 21A correct? So that would be an ok fuse to put in
05-23-2013 08:46 PM
tlminh Correct, each wire would be 55w/12v = 4.58 A

So a 5A fuse to each light?
05-23-2013 08:03 PM
jkjeeper06 I'm not sure of the amp capacity of each wire(normally I just look it up) but provided you have 4 outputs out of the relay, your wires will carry 4-5.5 amps each depending on battery voltage(14-10v respectively). If you put another inline fuse on each, you could guarantee too much doesn't go thru the wiring
05-23-2013 07:54 PM
tlminh
4 x 55W bulbs for rock lights - Wiring questing

I have 2 sets of wally world platinum burners (55W per bulb) and was going to connect them to a single relay and single switch

55W x 4/12V = 18.3A

Therefore, I am using a 12G with a 30A fuse 6 inches from the battery

This connects to a relay (Relay clip 30)

Questions : can the rest of the wires be all 16G?

From the relay clip 87, 1 set of 16G wires comes out, then the other set of 16G will be spliced into this?

Not quite sure, I did something similar 10 years ago with some neon lights and my toyota and my wires fried, thank goodness for the fuse

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 01:10 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC