|06-08-2013 01:34 PM|
Mine is a 97 TJ, sounds easy enough. Sounds like u work like I do got to be shure to get them beer breaks in. Thanks for the good advice.
|06-08-2013 01:27 PM|
What Jeep? Pretty easy on a TJ. Unbolt sway bar links, and the lower shock mounts. Jack up Jeep as high as you can and set on jackstands just behind the control arm mounts. Take front tires and wheels off. Let one side of axle droop to the ground while you jack up the other side. Should be able to yank the stock springs right out on the drooped side. I've done it by myself with 3" springs, but it's easier with a friend to push and pull on stuff. Hardest part could be getting the bump stop cup unbolted if it is rusted. The bolt is under the bump stop that you will have to remove from the cup.
In these pics I was removing a 1.5" spacer on top of my 3" springs and replacing with a .75" spacer. Took about an hour and a half, by myself, with a couple beer breaks.
|06-08-2013 12:51 PM|
Coil spring spacers
Hello folks, I have a set of coil spring spacers ordered. I am going to just put them on the front to raise the front end and give it the stance I am lookin for, anybody know how it of a job it is to put these in? Don't look like thyes much to it but I have never messed with coil springs much?