Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ Tech Forum > Nut in Frame Rail Spinning! X-p

Join Wrangler Forum Today


Thread: Nut in Frame Rail Spinning! X-p Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
07-05-2013 12:24 PM
UnlimitedRubicon My bumper came with flag nuts to use on those bolts. Isn't there a hole on the underside of the frame? Do you have a small pry bar or something similar that you can use to jam the nut enough to loosen it?
07-05-2013 11:52 AM
Holton345
Nut in Frame Rail Spinning! X-p

In the photo (from AtoZ Fabrications) is the driver side frame tie-in for one of Zach's rear bumpers.

I have no issues with the two nuts on the right, and the second nut from the left (the rearmost to the two with nuts, lock washers and washers inside the frame rail), but the leftmost (forward most,too) nut is not reachable by anything I have around here, my 3/4" box end wrench has a 45° offset and the hole in the bottom of the frame rail is just too close to it to allow it to get anywhere near where that nut has to be.

I *think* that a 90° box end wrench would make the nut center on the hole just right. But no one here has ever heard of such a wrench. I have some, but they all are too small.

Any ideas? Holding with my fingertip resulted in a pretty sore fingertip.

Any online source for such a wrench?

I also could try to braze a brass rod to the nut, but have never had much success with brazing to steel. No welding possible at this time...

Trying to get this bumper problem sorted for four days now. Getting frustrated...

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 06:27 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC