Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > General Jeep Discussions > Builders Corner > how do you remove a rear corner panel on a yj?

Join Wrangler Forum Today

Thread: how do you remove a rear corner panel on a yj? Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
08-04-2013 12:00 AM
beardown Yea figured that was the way, thanks
07-31-2013 08:30 PM
krisbman Find the spotwelds first. Either drill out each spotweld or use a cut off wheel to grind each weld until you reach the panel under the weld.
07-31-2013 12:17 AM
nick50471 Sawzall or angle grinder or both. Find a donor and start cutting. You could always buy some cheap armor and cover it up like lots of other folks.
07-30-2013 11:32 PM
how do you remove a rear corner panel on a yj?

my rear corner panel is rusted pretty bad and need to replace it!! how would i go about removing the old one? thanks

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 02:03 AM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC