Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > JK Jeep Wrangler Forum > JK General Discussion Forum > Problem removing stock steering stabilizer bracket

Join Wrangler Forum Today

Thread: Problem removing stock steering stabilizer bracket Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
08-18-2013 05:00 PM
SpartanGA Well. I compromised. Lol. I decided it would work as well as the RC supplied bracket to attach the stabilizer shock and just reused it on that passenger side. Works perfectly. So far.
08-18-2013 03:20 PM
Big Fran I had the same problem getting mine off. I used a large pry bar and was able to get it off near the passenger side end. Good luck. I scraped a few knuckles getting mine off.
08-18-2013 03:17 PM
kjeeper10 I was able to pry it off. It's a PITA. Are you reusing it ?
08-18-2013 02:49 PM
Problem removing stock steering stabilizer bracket

I have a frustrating problem that all DIY and videos online dont show the same problem.

I am removing my stock steering stabilizer and all that is left is the stock tie rod bracket. It is held in place with a single bolt (more videos show ubolts or similar, which this is not that bracket). This only loosens the you can turn it or slide it up/down the tie rod.

The issue is removal. I have tried to pry it apart so you can pull it off, but cannot seem to get the right angle and it is quite stiff and dont want to damage anything.

I managed to get it all the way to the passenger side where the tie connects to the hub where it is much smaller in diameter, but it still is too large/tight. I even tried the brute force hammering to just get it to widen and slip off. it is very stiff.

Advice here? Such an easy job and there is always something small like this that is annoying.


Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 12:07 AM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC