Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ General Discussion Forum > Mismatched part?

Join Wrangler Forum Today

Thread: Mismatched part? Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
08-27-2009 03:22 PM
Pylonpounder There's a pep boys (I hate them...) and an autozone...but both are way farther away than the advance. But eh, the hose appears to be in good condition- no swelling or sponginess, or rust on the ends, so I'm probably just going to send the part I ordered back, and use the stock one.
08-27-2009 12:26 AM
morphious wow really freaking advance is their anyone else i ur town for auto parts if their is then i would just take the part down their and see if they can match it to another block
08-26-2009 06:15 PM
Pylonpounder Tried Advanced auto first- Part was discontinued. front brake hoses I got from them, but the rear brake hose was discontinued.
08-26-2009 06:05 PM
coachchuck Your jeep is new enough that you should be able to get replacement parts for the brake lines at your local auto parts store. I don't know your location, so you might not have a auto parts store close.
08-26-2009 05:53 PM
Mismatched part?

94, 2.5, 5 speed, blah blah blah. Re-doing all the brake lines and hoses...and I ran into a slight problem. I ordered the replacement rear brake hose for 90-95 wranglers, the only one quadratec had, and while it DOES have all the holes necessary where it mounts to the rear axle, the center hole in which the bolt/hose goes down to hold it onto the rear wayyyy too small, and the block at the end itself is much smaller than the stock part. This...perturbs me. I can probably use the old one again, but I don't particularly want to..anyone have any explanations for what I'm sure is a dumb mistake on my part?

Edit: Also, the connector on this new hose that connects to the steel brake lines is far too big for the stock part.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 06:31 PM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC