Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ General Discussion Forum > Where to buy a new panhard bar mount...

Join Wrangler Forum Today


Thread: Where to buy a new panhard bar mount... Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
11-03-2009 07:04 AM
mnstrbetle YUP, THAT'S IT!!! Thanks! I knew the guys on this board could figure it out, your all awesome!! If it were my jeeop I would just remove it and leave it off but it's not mine. In NY it needs to be on there and tight or it won't get an inspection, now if we were to simply cut all the mounts right off and make it look like there was nothing there in the first place then nobody would even notice anything different. I'll be in contact with rough country today!! Thanks again!!
11-02-2009 09:23 PM
rcajper I dont have front or rear on mine , and I crawl pretty hard
11-02-2009 09:22 PM
rcajper take the trac bar off the front and rear , you really dont need it .
11-02-2009 09:01 PM
cheapjeep71 I had one on my jeep; but removed it. The panhard bar makes a good pry bar but is unneccessary on a leafspring vehicle. I haven't noticed any ill-effects & I drive mine on & offroad.
11-02-2009 08:59 PM
mbusby Im sure they would be able to sell you another one if you contacted them. adam at rough country has been very helpful to me.
11-02-2009 08:57 PM
mbusby the bottom bolt mounts through the existing axle hole and there should be another bolt going through the axle that has been drilled.
11-02-2009 08:56 PM
mbusby thats a rough country track bar relocation bracket that comes with their 4 inch lift kits.
11-02-2009 07:24 PM
mnstrbetle OK, here's a crappy cell phone picture of the mount on the top of the axle.
Does anyone know where I can get a mount like this or one that will do the same thing??
11-02-2009 02:23 PM
mnstrbetle Yeah, I'll take a picture tonite. I have to go over there to drop off some pictures. I'll have to take the pic with my cell phone cuz my wife took both of the cameras with her and she'll be gone all week.
11-02-2009 12:47 PM
turdhurdler I have completely removed my rear trac bar and my front sway bar is disconnected. With leaf springs, you get a more rigid ride than with a set up like on newer Jeeps.

Can you take a picture and post what you have. Different people use different terms to describe the same thing. I just want to make sure we are on the same page.

Jeff
11-02-2009 12:34 PM
mnstrbetle We're not sure what the lift is in it. It looks to be a three inch spring lift. We're not even sure who the manufacturer is... I just read on another thread that the front and rear track bars can be simply removed! Is that no Joke? Can you run a jeep without the track bars?? Seems like it would wander worse than a horny 14 year old!!
11-02-2009 12:27 PM
turdhurdler What manufacturer of lift do you have? You may be able to order the part directly from them. Most mfg. will have a picture of the entire lift kit for ordering purposes so that the customer can see exactly what they are getting.

Jeff
11-02-2009 12:21 PM
mnstrbetle Apparently it's called a 'Track Bar Relocation Bracket' but the ones I've seen in quadratec don't even look remotely similar to what he's got on his jeep.
11-02-2009 12:09 PM
mnstrbetle Nope, that's not it. This mount bolts top the top of the axle and it's sole purpose is to lift the mounting position where the panhard bar connects to the axle. For axample, with a three inch spring lift the panhard bar needs to be lifted three inches as well and this mount would accomplish that task. it looks similar to a mount that a TJ would use.
11-02-2009 09:42 AM
jeepers92 Track Bar (Panhard) Bracket by Blue Torch Fabworks and Other Jeep Parts and Jeep Accessories by 4 Wheel Drive Hardware is this it?
11-02-2009 09:29 AM
mnstrbetle
Where to buy a new panhard bar mount...

Good morning everyone. One of my closesty friends has just bought a YJ, it has what looks to be a three inch spring lift on it. Upon my first inspection of the vehicle we discovered that the mount for the 'axle end' of the panhard bar was loose and wiggling all over the place. All of the holes have become oversized and egg shaped...sooo my question is this: Is there anyone out there in the Jeep aftermarket industry that will just sell me that little mount? There really isn't any reason to buy a complete lift kit because the leafs are in good shape, it's just that this little mount is junk. Does Quadratec sell this little mount? Anyone have a part number because I'm having a hard time finding it online and I don't have a catalog. Thank you!!!!

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 11:20 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC