Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ Tech Forum > P420 Catalytic converter replacement help

Join Wrangler Forum Today


Thread: P420 Catalytic converter replacement help Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-16-2010 03:11 AM
rrich Find another muffler shop - not a chain like Midas or Pep Boys. Find a small independent one that other shops near it recommend.

The small dual cats from a dealer are about $700 - but there is not much to go wrong. It would take an awful lot of crud to plug one up.

The big one may go as high as $200. It's just a standard CAT, nothing trick about it.

Even if you needed both, 700+200+labor, it's a far cry from 2K.

And before replacing anything - reset the computer back to default. No matter what others say, there's really only 2 ways you can do it.
1. Use the Chrysler DRB III diagnostic device - not sure of the price but over $10,000.
or -
2. Disconnect the battery for at least 12 hours.

To me, #2 makes more sense.

Clearing codes with a scanner only clears codes, it does not return the computer to default.
There are lots of rumors how to clear the memory quickly - some partially work, most only clear the codes but do not reset the internals. You want it ALL reset.

After the 12 hours, reconnect, then you need to drive it for about 20 miles - drive it easy for the first few miles, then faster and harder. It has to re-learn everything.
A scanner at first will tell you that the battery was disconnected - then as more and more portals open up, it will show any faults that exist. It can take as long as 100 miles before all the portals have opened and it's back to normal.

CATs fail in 2 ways - plugged - due to overheating from a misfire. A vacuum gauge will tell you if it is plugged, not the computer. An infrared laser type thermometer works even better to find a plugged cat.

Guts blown out - The computer detects there's too much O2 getting to the downstream O2 sensor - an exhaust leak or a bad O2 sensor can do the same.

Why are you suspecting a CAT problem?
05-16-2010 12:05 AM
doclouie Had a cat replaced for 250 and it was a high flow one. Find another muffler shop.
05-16-2010 12:03 AM
stevens243 It may be likely that the cat is shot with the age and amount of miles on your jeep but that code does not mean that it IS the cat.

Could be an exhaust leak or a bad O2 sensor also.

If the senors are stock (and you'd have to replace them anyway) try to troubleshoot and replace them to see if that solves it and check for leaks too.

Much cheaper than (the total rip off price of 1800 you were quoted) replacing the cat.
05-15-2010 11:28 PM
Wrangler Juice Damn Brother... that much for a replacement of a Cat? I have the same problem on my 2000 sport and would like to replace it myslef.

I have found that maybe the slide plate on the under carrige might be in the way for me to see how bad the job would be. I have priced out the Cats for our jeeps from $69 ll the way up to $115.00 on a google search.

Searching around a bit I have foudn that the Cats on the jeeps are fairly cheap, but the expensive thing is on the welding of the pipes if nessesary.

Check out WikiAnswers - How do you replace the catalytic converter on a Jeep Wrangler

for more info.

Juice
01-21-2010 02:29 PM
jademonkey33
P420 Catalytic converter replacement help

ve been lurking for a while, but finally have a question ive had some trouble answering on my own.

I have a 2000 Wrangler Sport 6Cyl with 105k on it. It spit out a P420 code recently and know that means that the cat is done for. I took it to my local shop in Maryland and they said it was going to be 1800 to fix it with parts and labor. I would really, REALLY not like to pay close to 2k for this and wanted to see if this was something i could do on my own. I came up with a few questions and wanted to see first and foremost if this is a doable job - (im good with my hands but all ive really done is rotate tires and change my own oil). Thoughts?

I found Eastern
Eastern Catalytic Converter Direct OE replacement
on another post in the forum but for another year and wanted to see if this would work. I also dont know if i need to replace the O2 sensor as well with this replacement or if i can use the old one.

I am not really in a rush and dont have emissions coming up or anything, but i would like to see if any of the above would work. Any help or advice you can give me would be GREATLY appreciated.

Thanks

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 07:32 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC