|06-23-2010 11:25 AM|
Personally, for the AX-5 transmission the OP has, I recommend Redline MT-90 which is a synthetic GL-4 75W-90. There are a few synthetic 75W-90 GL-5 gear lubes that are ok like from Royal Purple and Amsoil, they clearly state they are safe for "yellow metals" which is what the synchronizers are made from. But they are the exception to the no-GL-5 rule, most GL-5 gear lubes are unsuitable for use in either the AX-5 or AX-15 Aisin manual transmissions.
|06-23-2010 08:55 AM|
I just did this last weekend, and thought I would share some pics and my experience.
Please note that this is ONLY for the Jeep Wrangler TJ models with the NV3550 manual transmission. While other transmissions are similar, there may be small differences, including the location of plugs, types of fluids used, and other necessary items. Always check your particular vehicle to be sure before beginning.
To begin, you will need the following:
3 Quarts of Synchromesh or similar gear oil, a pumping device or funnel.
A 17mm hex bit, a socket wrench and possibly a breaker bar.
Not shown is an oil drain pan and some anti-seize lubricant.
Step 1 - Get the vehicle up on jack or ramp stands.
Step 2 - Ensure you can loosen the FILL Plug, located on the driver's side of the housing, BEFORE opening the drain plug.
Step 3 - Open the drain plug and allow the old gear oil to drain out.
Step 4 - As the fluid drains, inspect the drain plug. As you can see, it houses a magnet to catch stray metal strands. This should be cleaned before reinsertion.
Step 5 - Apply a small amount of anti-seize compound to the drain and fill plug threads. Then after reinstalling the drain plug, use the pumping device or funnel to deliver new clean fluid to the housing. Fill to the bottom of the fill plug, approximately 2 liters.
Step 6 - Reinstall the fill plug, then take a short drive being careful to observe shifting smoothness and then check for leaks.
Step 7 - Dispose of the old fluid in a responsible manner. Do not just dump it in the sewer grate down the street because you figure if BP can do it so can you. That is not responsible. Just take it back to the place you got the tools and fluids from, they will likely be able to recycle it for you.
|05-01-2010 12:47 PM|
Thanks for the help. I did figure out from the pictures that I do have a AX-5.
I was told by the Chrysler patrs guy to use 10-30 motor oil in the AX-5............? Also told don't use GL-5.....has to be GL-3.........
|05-01-2010 05:08 AM|
|meyers||Extra Virgin Olive olive, and I throw some crushed garlic in there as well helps the synchronous synchrony synchrotron actions, plus it smells nice|
|04-30-2010 11:38 PM|
|Jiffydarren||75w90 works. As long as it's GL5.|
|04-30-2010 09:40 PM|
|04-30-2010 09:35 PM|
|jwm1986||wrong again.. i should just stop answering questions|
|04-30-2010 09:22 PM|
^^^^^ nope..NV3550 is behind the 6cly.
wranglersteve your transmission is the AX-5...Redline MT 90 or Redline MTL works great!!! in that trans. Can pick it up at some autostores..or order from jegs.com or summitracing.com.
And for everyones transmission curiousity need....
|04-30-2010 07:44 PM|
More than likely you have the NV3550. Check out this link, should clear things up for you.
Jeep NV3550 Transmission & NP231 Transfer Case Service
|04-30-2010 07:33 PM|
5 speed manual question.....HELP
I have a 2000 wrangler, 4 cylinder, 5 speed manual. I want to change the transmission fluid. Haynes manual list 4 transmissions.......AX-4/5, AX-15, NV1500 and a NV3550. Anybody know which one I have and what fluid to use?
Thanks for the help!!