Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > need advice on pinion angle for 8.8 swap

Join Wrangler Forum Today


Thread: need advice on pinion angle for 8.8 swap Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
09-22-2010 07:00 PM
Snuffy115 Take a look at this. It will answer all your questions.

Tom Wood's Custom Drive Shafts - Tom Woods Custom Drive Shafts Custom Driveshafts Specialist
09-22-2010 06:51 PM
Monkeywrench1 Mine is about 6 degrees the pinion points just to the bottom of the bolt or yolk on the transfer case this is so under load the pinion points at the yolk on the t case
Hope I helped rubicon express sells
The degree shims
09-22-2010 06:41 PM
Mikedavis33
need advice on pinion angle for 8.8 swap

Hello All-

I am going to swap my Dana 35 with a ford 8.8 and need some advice on the pinion angle. I am going to do a SYE and CV shaft. I have read that if you plan to do a CV shaft to point the pinion dirrectly at the transfer case as opposed to parallel like stock or with a standard shaft. A few of the ones I have seen done online keep the pinion like stock. Any advice???

Some additional info:
92 YJ 4.0L
4" rough country lift
plan to swap my 33s for 35s
I would prefer to do a SOA but will most likely keep the spring under the axle due to the labor invoved in the front...

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 07:21 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC