Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > Rugged Ridge Header Fit Issues

Join Wrangler Forum Today

Thread: Rugged Ridge Header Fit Issues Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
10-02-2010 10:51 AM
Jerry Bransford Headers help performance when they replace an exhaust manifold. But the TJ 4.0L comes with a factory header already so you're not going to see that normal bump in performance an aftermarket header can cause.
10-02-2010 10:46 AM
haleycbrrr Im strongly considering a rugged ridge 409 stainless header for my 06 TJ 4.0L...and now im curious if I'll run into similar fitting issues, aslo I'd love to hear what some people think about the header in question. I read on another thread that banks tends to crack for lack of a flex joint? how does the RR hold up? and if you've installed it, hows the performance gain? Im not terribly obsessed over sound, I just want my motor as efficient as I can make it, and since I have it breathing better on the intake side (ported throttle body, and K&N intake) I figure I should do something about the exhaust side now. any thoughts and advice are appreciated.

09-03-2010 07:47 PM
AzTJ Any way to take a picture of the areas you think are the issues?
09-03-2010 07:44 PM
Rugged Ridge Header Fit Issues

I went to put in some new Rugged Ridge t-409 SS headers on my 97 TJ and couldn't get my intake manifold back on. It seemed like the metal around one of the pipes was too big to let the intake manifold slide past.

I needed wheels so I ended up pulling them back out and putting my cracked exhaust manifold back on for the time being.

Has anyone else had this problem??

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 03:39 AM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC