Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ Tech Forum > quick disconnect install & removing front sway bar

Join Wrangler Forum Today


Thread: quick disconnect install & removing front sway bar Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
10-24-2010 06:11 PM
03 RUBI If you're going to replace the sway bar bushings I suggest getting greaseable ones.
10-23-2010 11:16 PM
Splnkr Had the same issue with my disconnects. Used a pickle fork and a puller plus a big hammer to pop them free....

10-23-2010 11:02 PM
distortedtj The factory links can be a pain to get out of the swaybar. A few things you can try...first..a 3lb hammer works nicely, give it some good wacks. You can try a pickle fork to remove them at the joint.

As for the swaybar bushings...you can cut the head off of the bolt to remove it then install a nutsert into the factory hole and reinstall the new bushings.
10-23-2010 09:14 PM
Curt93acw
quick disconnect install & removing front sway bar

I just put a 2" budget lift (3" coils up front & 2" spacers in the rear) on my 97 TJ so I decided to get some quick disconnects. They seem to be a pretty straightforward install; HOWEVER, I'm running into a couple snags.

1st snag - at the end of the sway bar (where the new quick disconnects will attach) are the things with the bolt on the top end and the ball on the bottom (sorry, I don't know the names of some of these parts). How in the &^%$ do you get this thing off?!? I sprayed some PB Blaster on it and still not budging.

Sooo, when I couldn't get those things off I decided to take the entire sway bar off. I figured I would replace the sway bar bushings while it was off.

This brings me to the 2nd snag - of the two bolts (the front and rear) that attach the bushings/sway bar to the frame, the rear ones have nuts inside the frame that are spinning as I turn the bolts. I'm not having any luck getting a wrench inside the frame.

Any suggestions/ideas?

Thanks once again for all the help!!

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 06:17 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC