Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > YJ crank position sensor

Join Wrangler Forum Today


Thread: YJ crank position sensor Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-03-2011 02:02 PM
birtydugger Yeah u got one...they do go bad especially if water penetrates it!..dont jet-wash ur engines or go fast through rivers they hate it!!!
01-03-2011 01:15 PM
MetsFan978
Quote:
Originally Posted by YJ designer View Post
It is fuel injected.. does it still have TPS?
Yea, you have a TPS. Think it's a requirement on any gasoline engine.
As posted earlier, it will be screwed into the throttle body on the driver's side facing the firewall. There's a 3 wire plug that goes into it.
If you have a multimeter you could test yours, but they aren't expensive to replace and they can go bad.
01-03-2011 12:51 PM
YJ designer It is fuel injected.. does it still have TPS?
01-03-2011 12:49 PM
birtydugger TPS...Throttle Position Sensor...try changing that...its on the back end of the throttle-body (carb) facing the firewall...it has a conector plugged into it..pull it out and undo the 2 torx screws..put new one in...
Throttle Position Sensor for 91-95 Jeep® Wrangler YJ
01-03-2011 12:32 PM
YJ designer Thanks.. will check them.
01-03-2011 12:29 PM
Timberwolf fuel filter or pump?
01-03-2011 12:25 PM
YJ designer
YJ crank position sensor

Have '91 YJ, building for 2 yrs. and drive most days. Other day it turned over but won't start. Distributor cap, rotor and wires are new. I tested coil and it was fine. Mechanic tested and replaced crankshaft position sensor, but now it won't start unless gas pedal is pushed to floor board. Never in 2 yrs have I touched the gas pedal when starting the jeep. Why now is this required for it to start? I thought fuel injected engines, you should never touch the gas pedal and now I have too.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 08:40 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC