Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > JK Jeep Wrangler Forum > JK General Discussion Forum > Changing rear brake pads

Join Wrangler Forum Today


Thread: Changing rear brake pads Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-06-2011 06:58 PM
seadog Very informative link, Daggo66. As far as the pics go. I just use a trick my grandfather taught me and I don't have to bleed the brakes, at all.

If you monitor your brake wear, on a regular basis, you should never have to add fluid. The cap is designed to adjust to to the fluid levels in the brake lines, with normal wear and tear. Ever had to push that rubber liner back into the cap? If you have to add fluid, you probably have a leak.

The trick? When you start to disassemble the brake caliper, the shoes will probably be lodged against the discs. With the Master Cylinder cap ON, take a large screwdriver (or punch) and gently push the the shoe/caliper in. Do not wedge the screwdriver between the disc and pad. That will score your rotor. Disassemble as shown in the link.

Using the old brake pad and a C-clamp (I use a 6 inch normally, but one car took an 8 inch), compress the cylinders until they clear the new pads and rotor. Reassemble as shown.

When done, start the Jeep and gently depress the brake pedal a few times. You'll feel the pressure build up. Drop it off the stands and drive it slowly around the block. Hit the brakes a few times. Check levels and add if needed (probably not). Also check each brake line for fluid leaks. Shouldn't be any, but you never know with reassembly.

Since you didn't really open the system, there should be no air in the system. So, you don't have to bleed the system. I've done this on over 30 vehicles and never had a problem. Except for the one that blew out when I used the clamp. After the rebuild, I used the traditional bleeding sequence.
01-06-2011 01:12 AM
Mikial Ive always wondered how a mechanical parking brake works with a rotor and pad? I guess i'll find out when I have to do my rear brake pads but that won't be for a while because I just got my 11 rubi two weeks ago.

Mik
01-06-2011 12:18 AM
Wallygator I would recommend hitting them with a scuff pad and some brake clean just to get rid of the glaze even if the rotors are ing good shape. Just makes them work better. And lube the parking brake hardware while you are in there or it might do like mine did and seize.
01-06-2011 12:04 AM
_3m if they look worn yes if they are in good shape then no
01-05-2011 11:28 PM
Mikial Shouldn't you have your rotors turned when ever you have a brake job, or was that a requirement with drums?

Mik
01-05-2011 02:03 AM
_3m super easy, you'll spend more time with the rim and jack than you will with the pads themselves. i did mine in the snow, in about 35 minutes
01-05-2011 12:57 AM
climber DAGGO 66 Thank you! Big Help.......
01-04-2011 06:23 PM
h2otoo Nice link, '66. Thanks.

Bob
01-04-2011 05:44 AM
daggo66 Project-JK.com - Jeep JK Wrangler Resource » Jeep JK Wrangler Maintenance Rear Brake Pad Replacement
01-04-2011 02:46 AM
jeepjones Very simple job.
01-04-2011 02:09 AM
climber
Changing rear brake pads

I was just in for my oil change and the dealer told me i need to change my rear pads. I have a 2007 jk unlimited sahara. I have changed brake pads once a long time ago. How difficult is this to do?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 01:46 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC