Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > Wiring a YJ for Trailer Brakes

Join Wrangler Forum Today

Thread: Wiring a YJ for Trailer Brakes Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-19-2011 05:14 PM
Trailer Wiring Questions

Hi All

My choices for locating the controller under the dash are either here.....

or here...

I believe I will have to go with the location shown in the second picture since there is an RF sensor for my alarm system in the same location as the controller in the first pic but, according to the brake controller instructions it needs to be 12" away from any RF sources.

The next question has to do with getting the battery power wiring from the battery through the firewall to the controller. The most likely way is through this fitting/port.....

It looks like I can poke a hole over the existing wiring and run my cables through there.
Is this the best way to do it?

I also need to mount a couple of these circuit breakers near the battery......

Is this location on the firewall behind the battery OK to use? ....

What is on the other side of this firewall?
I do not want to accidentally drill a hole though the heater core or computer, etc..


Randy from Burbank
01-19-2011 03:19 PM
Wiring a YJ for Trailer Brakes

Hi All

I recently acquired a utility trailer that has electric trailer brakes installed. This trailer weighs 1300lbs unloaded and will weigh 2000lbs fully loaded.

Has anybody wired up their YJs with a trailer brake controller?

My '95 YJ is stock with 105K miles. It is a 4.0l, with a 5 speed, stock suspension and 235/R75 x 15 Pirelli Scorpion Mud/Snow tires.

The jeep already has a Hidden Hitch frame mounted hitch rated at 3000 lbs and a 4 prong trailer wiring kit installed. I will be adding to this a Tekonsha Prodigy P2 controller...
Tekonsha Prodigy P2 Brake Controller - Proportional Tekonsha Brake Controller 90885

and wiring up the brake controller using this wiring kit...
Brake Controller 7 & 4 Way Installation Kit - 10 Gauge etrailer Brake Controller ETBC7

My questions:
  • Where to install the controller in the cab
  • How to get power cables from the battery through the firewall to the controller inside the cab
  • Where to mount the circuit breakers inside the engine compartment.
  • How/Where to route the cables from the battery back to the trailer hitch
  • Where to mount the trailer wiring connector/socket on the back of the jeep.
I will post some pictures shortly.


Randy from Burbank

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 02:43 AM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC