Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > Turn Signal Dilemma | I replaced fuse and canister

Join Wrangler Forum Today

Thread: Turn Signal Dilemma | I replaced fuse and canister Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-02-2014 10:50 PM
crabman141 I did replace the right side canister and the turn fuse. Neither left or right work. The hazards do however. Going to try to get the stalk out this weekend, or at least find a DIY for it.
05-02-2014 08:40 PM
YJ94YJ nice catch on the diagram... maybe i should look over it more carefully next time... great advice though jeff
05-02-2014 12:56 PM
jeffs92yj There are two flashers in that diagram, one for the hazards and one for the turn signals.

Also two different fuses.

Make sure you replaced the correct flasher.

Working from that diagram, if the hazards work, the bulbs are good.

Since the turn signals are on individual (left / right) switches, it would be strange if both went bad at the same time.

That pretty much leaves the turn signal flasher or the wiring from the flasher to the turn signal switch(es).
05-02-2014 08:52 AM
crabman141 Thank you so much YJ94YJ. Much appreciated, I'll look into it this weekend and report back.
05-01-2014 11:23 PM
Wiring Diagram for turning signal circuit attached

Looking at this circuit if you hazards are operating properly then the only weak link is you turning signal switch
05-01-2014 11:01 PM
YJ94YJ Ill have to dig around and see if i have a wiring diagram but if your hazards are working you know the flasher is fine so there must be a problem on the switching side of your turning signals.
05-01-2014 09:40 PM
Turn Signal Dilemma | I replaced fuse and canister

I have a '95 Rio and replaced the canister and fuse, after my turn signal went out(burned the fuse). As far as I know the canister didn't need to be replaced, but did it anyways to make sure that wasn't the problem. The hazards work fine, just no blinkers.

Is there a wiring diagram some can show me or PM me would be greatly appreciated. Any input would be awesome.


Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 08:28 AM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC