Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ Tech Forum > Engine light on tj

Join Wrangler Forum Today

Thread: Engine light on tj Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
02-03-2011 02:10 PM
Peepers do your brake lights work? or stay on all the time?
02-03-2011 02:09 PM
Jerry Bransford Disconnect the battery's negative lead for 2-3 minutes to clear the code. Probably just a temporary glitch. Don't worry about the code unless it comes back again. No need to go to Autozone to read your TJ's diagnostic codes, use the technique given to you by Littleyellow to read your own codes in the future.
02-03-2011 02:06 PM
jefferyfghezzi Went to AUTO-ZONE. There is only one code P0573 Brake switch circuit. Look in HAYNES and it says Cruise control/brake switch A,circuit high. What does this mean?
02-02-2011 04:16 PM
Littleyellow There is a kew trick to flash the code... We need the code to diagnose anything.., or just take a ride to autozone or a parts place. Most read codes for free.

Thw key trick is put the key in, turn in to on then off 3 times and leave the key in the on position. You must completle the key cycle in 5 seconds and the code should pop up ie... pxxxx
02-02-2011 04:11 PM
Engine light on tj

I was plowing snow and got hung up. All 4 wheels were up in snow. I finally got out with shoveling and rocking. 2005 X automatic 6. Now my engine light won't go out. Oil, water,tranmission fluid all good.Runs fine but the light won't go out. I plowed for 2 hours with the light on and no problem. Sounded normal and no overheating smell.The only other issue is I had trouble getting in into 2w/4whi/4wlo. It seems fine now I think I had snow where it should not have been. I lifted the blade and tried to push the top of the pile with a running start and ended up ontop of the pile. The light is not flashing only staying on.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 08:23 AM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC