|02-05-2011 10:57 PM|
|doclouie||I am pretty sure they do make Ranchos for that size lift. I got my Rancho 9000s from my4by.com and they only were like $62 a shock shipped with a lifetime warranty. Check this out. Rancho RS9000XL Shocks | Jeep Wrangler TJ 1997-2006|
|02-05-2011 07:25 PM|
|drl650||My new Skyjacker Hydros are a big comfort improvement over my RE shocks.|
|02-05-2011 04:06 PM|
|TJe0454||i am very happy so far with my skyjacker hydros|
|02-05-2011 03:50 PM|
|Arch Stanton||What about KYB Gas-a-just or ORV Shocks?|
|02-05-2011 03:34 PM|
I am also looking to buy new shocks for my '03 Wrangler.
I did a little investigation and Rancho9000XL do not make shocks that will fit a Wrangler with a 4 inch lift. The only ones I saw was up to 2.5 inches. Please correct me if I'm wrong.
|01-08-2011 04:18 PM|
I read this post below among others. However, if OME used twin tubes it must be for a reason, as these shocks are well rated. I've read many of your posts on this and the other forum and you seem to know what you are talking about. Thanks for the post.
Mono-Tube (Single Wall) Shock Absorbers
Itâ€™s not often that one is better than two. These shock absorbers use a single-walled tube to enclose the piston, the oil and (sometimes) the pressurized gas. These shock absorber types are much more precise at dampening than the standard shock absorber because they are made with considerably more precise standards during the manufacturing process. Additionally, in most cases, the single-wall shock absorber is considerably stronger than the twin-tube shock absorber because they typically use a larger diameter piston. Further, the single-wall absorber is more resilient to shock fade because it can divide the shockâ€™s oil from the air space far better than a twin-tube shock. With this type of construction comes the benefit of better heat dissipation as well.
|01-08-2011 03:56 PM|
|01-08-2011 03:25 PM|
Those are 35's
|01-08-2011 03:24 PM|
I don't know if this is your first time replacing shocks, but it is an insanely easy task.
There's a guide I wrote before about replacing the rear shocks. The fronts I believe are similar just unbolt and go. Don't cut he new shocks open too early until your installing them.
Jerry is correct in that you don't HAVE to remove your tires, but it's such a quick process that when I do the rear shocks I remove them. It gives you so much more room to work with. It's your call though.
|01-08-2011 03:12 PM|
|Arch Stanton||Thanks for the link. I checked it out. I'm going to give Rancho a call on Monday to see if they are a monotube shock.|
|01-08-2011 03:00 PM|
|Jerry Bransford||Rancho Suspension: Shocks » RS9000XL|
|01-08-2011 02:56 PM|
|Arch Stanton||I've read that these are nice riding shocks. I'm looking a smooth riding shock. There was a promotion for the Rancho 9000 shocks and a free controller. Maybe they'll offer another promotion for these shocks. Anyone know if these are gas-charged monotube shocks?|
|01-08-2011 02:53 PM|
|Jerry Bransford||For less than $400, I'd rather have Rancho R9000XL shocks that are adjustable and are a superb quality shock.|
|01-08-2011 02:36 PM|
|01-08-2011 02:34 PM|
|01-08-2011 02:30 PM|
|knnphillips||Post a picture of your lift components someone should be able to tell you what size you have. I think shocks go 4 - 5 inch lift so I would go with that length if it was me but I would see if anyone recognized the lift first.|
|01-08-2011 02:28 PM|
|Arch Stanton||It's too bad the Bilsteins don't have a warranty. If they did, I consider buying them. I've read good reviews of the 5100's.|
|01-08-2011 02:27 PM|
|Jerry Bransford||Knowing the right model # to order based on your vehicle and lift size is the dealer's job who you buy them from, not yours.|
|01-08-2011 02:24 PM|
|Pierce07||Ya I'm kinda worried about ordering them. I'm not 100% sure what size lift I have. I think it's about 3.5-5" not sure though. Any suggestions when not knowing the exact height?|
|01-08-2011 01:47 PM|
|knnphillips||The bilstein 5100s aren't expensive you just got to do a little Internet search determining which length you need. Mine cost under 300.|
|01-08-2011 01:40 PM|
|01-08-2011 01:36 PM|
|Jerry Bransford||No need for a front-end alignment after replacing shocks. One set of decent low-cost shocks that get mostly good reviews for ride quality are Skyjacker's Hydros. You can replace your shocks very easily, you don't even need to jack the Jeep up or take the wheels off.|
|01-08-2011 01:35 PM|
Shocks that Don't break the bank?
It's time for some new ones looking for some recommendations. I have about 4 inches of lift on my jeep
Also if i put new shocks on would there be any need to get in realigned?