Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > Skyjacker Hydro 7000 shock installation question

Join Wrangler Forum Today


Thread: Skyjacker Hydro 7000 shock installation question Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
02-09-2011 01:55 PM
PTaylor Thanks for the response drl650, That sounds like the best solution.
02-09-2011 01:33 PM
drl650 I tightened mine to a slight compression. I put double nuts on mine so they wont back off.
02-09-2011 11:15 AM
PTaylor
Skyjacker Hydro 7000 shock installation question

the front shocks come with two small red bushings and two metal washers for compression to install on the top side. No problem with assembly but how tight am I suppose to put this. I can turn the wrench with very little force and compress the red bushings, and if I keep turning them, very easily again I might add, I can eventually almost compress those bushing until they are bulging.

Those bushings are different from the ones I removed. The ones removed were wider and flatter, made of a harder rubber. These have a smaller diameter, are taller, and much, much softer. The ones I removed you can pretty much tell when you are starting to compress, but these new ones, no idea. If I tighten just enough to keep their shape, I'm worried it won't be enough torq on the nut to keep it from backing off. If I tighten enough torq to where it starts giving some resistance, like it's good and snug, what you would expect, the bushings are really compressed. I have no idea if this is good or bad but it seems the bushings are being compressed way to much and I should back the nut off, but backing it off and leaving the bushings in a good visual state just seems to leave the nut too loose.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 09:37 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC