|03-25-2011 09:31 AM|
|ttmanthey||Where did you pick up the material for the rocker plates and about how much did they cost if you don't mind me asking? They look great and so does the bumper!|
|02-15-2011 11:43 PM|
|02-15-2011 11:37 PM|
|bwilburn||The rockers are galv. steel, I can't say for sure how thick but I think around .075, with a rattle can satin black.|
|02-15-2011 09:28 AM|
Nice work. Are those rockers steel or aluminum? How thick? What did you finish them with. Bumper looks great.
|02-15-2011 08:06 AM|
Thanks for the complements. In reply to the questions. Dkdkgus- 1. cut it flush 2. I dont know why to tell you the truth. 3. No the go up to but not under.
Monkee2002- No dimensions, I was painting the flairs when I started puttin them back on I left the bottom screws out took a piece of thin cardboard put it behind the flairs and traced the curves of the flairs. Used that for my pattern.
|02-15-2011 01:08 AM|
how'd you make the rocker guards? Do you by chance have the dimensions? I've been thinking about doing that as well.
|02-15-2011 01:07 AM|
Looks good. Glad to see someone make their ideas a reality. Couple of questions, 1) did you roll the bottom under at all or just cut it flush to the bottom? 2) why did you end the top lower than the door? 3) do they extend under the factory flares?
I'm in the process of making my own custom rocker/sliders and just wondered.
Sent from my iPhone
|02-15-2011 12:26 AM|
|02-15-2011 12:25 AM|
|bwilburn||with painted flaires and stock bumper mod|
|02-15-2011 12:14 AM|
homemade rocker plates
G]cket.com/albums/j458/bwilbur1/christmas2010baby102.jpg[/IMG] These are some picts of my builds. The front bumper is a stock bumper chopped and holes welded and a hoop added. The rocker plates i made from some D plate and as you can see painted the flairs