Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ Tech Forum > tailgate hinge sticking

Join Wrangler Forum Today


Thread: tailgate hinge sticking Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-18-2010 10:47 AM
Keflaman
Longevity Report

Okay, so maybe four years later is a bit much, but at least it's something

Simple zerk installation: drill horizontal hole of appropriate size approximately 5/8" (16mm) from outboard edge of tailgate hinge and tap in zerk fitting.

Service with your choice of grease; I used marine grease.

My spare is a OEM Gambler w/BFG MT KM2 ~84lbs. I don't always carry a spare, but the times I have were pretty punishing for months at a stretch.
04-12-2006 09:47 PM
jeepmutt My spare rides on a swing out bumper so hinge strength isn't a concern. This seems like an ingeniously simple solution. Where exactly did you install the zerks? Just keep the drill bit horizontal and tap in until you hit the hinge pin?
04-03-2006 03:56 PM
Keflaman
Try Grease Zerks

I went the penetrant, oil, WD-40, etc route and nothing seemed to help. I finally drilled a hole and installed grease fittings in each hinge. I was carrying a 33" spare prior, but haven't had it on the tailgate for a couple of months so I don't know if the fittings would significantly weaken the hinges.
02-03-2006 04:19 PM
jbone303 my 98 did the same thing. What happened was the oxidation fell into the inside of the hindge.I just replaced it with stainless like khinderson said simple fix and looks lots better than a ball of rust under paint.
01-24-2006 09:15 PM
khenderson mine does the same, i've sprayed it with wd40 and it works for a little while, but always gets hard to close and open again.
01-24-2006 11:16 AM
cueball Do you have an oversize spare if so the extra weight might have damaged them.. Ive seen em made of stainless ..might be the answer
01-23-2006 10:13 PM
jeepmutt
tailgate hinge sticking

My '97 has had most of the paint flake off the tailgate hinges. They appear to be aluminum, and I have to fight to open and close the rear gate. PB Blaster and WD40 have done nothing to help. Do I need to replace these hinges?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 05:46 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC