|07-20-2007 12:14 AM|
Slip Yoke Eliminator - it changes the slip yoke driveshaft on the rear of the Jeep and replaces it with a double cardon (aka CV) style shaft. It lengthens the shaft a few inches, and the CV joint allows for much harsher angles. The output shaft is upgraded as well to a heavier unit (unless you do a hack and tap).
A SYE reduces driveline angles, driveline vibes (which WILL kill your pinion and output shaft bearings if ignored, and can crack your t-case), and beefs up the overall assy from the output shaft on back to the pinion yoke.
|07-20-2007 12:03 AM|
|shawn calvin||what is a [sye]? and yes it will get lifted 5" with 35" tires|
|07-19-2007 11:55 PM|
The transfercase in TJ's is a NP-231 - Chrysler uses these in v8 applications (Dodge Ram 1500s and such) so I would think it would be ok. Just make sure you put in a bigger input shaft and I would recommend a wide chain upgrade. If you're gonna shorten the rear drive shaft ANY, or lift the jeep any - with the extra power an SYE is a MUST.
|07-19-2007 11:29 PM|
can you run the stock transfer case out of the jeep?is the 8.8 what is in the ford explorers?
|07-19-2007 09:02 PM|
|debruins||it seems like you want to upgrade stuff so i would get a 4 cyl. they are less exensive, youll have to upgrade the tranny anyway, and you can put in a ford 8.8 for a round 700-1000 whihc i stronger than the D44 anyway|
|07-19-2007 07:18 PM|
|naterg||well... for one, I am almost 95% sure that all 4 cyl. came with the d30 fron d35 rear axles... which you will DEFINITELY want to upgrade if you are to drop in a SBC. Transmission will probably want to be changed too...|
|07-19-2007 06:27 PM|
4 cyl. or 6cyl. ??
is there any difference in the drivetrain on a 97 jeep with a 4 cyl. or 6 cyl. other than gears?
i am think of buying one with a 4 cyl. and puting a 350 in it. anybody try to use the stock transfer case. or does it take a shit right of the bat?any other info would be great.