Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > General Jeep Discussions > General Jeep Discussion > Coils vs. spacers

Join Wrangler Forum Today

Thread: Coils vs. spacers Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
03-24-2011 12:46 PM
cavsvet74 Thanks u-joint, that helps alot!
I have a 2010 Sahara that according to my build sheet, has gas shocks. I don't know if the length is the same as a Rubicon shock though.
I was looking at a 2.5" lift.

Thanks again.
03-24-2011 01:49 AM
u-joint Factory shocks are going to have a lower load rating (usually) than after market shocks. The big difference between a budget boost and a coil lift comes into play when you start adding after market accessory (winch, bumper, rock rails, etc). All of these things weight down your Jeep. Good, after market springs, are designed to handle this extra load without sagging. Your factory springs, however, are not.

Additionally, a budget boost is a polyurethane puck, and will give you EXACTLY what it advertises. So, if it says that it's a 2.5" lift, then you will get EXACTLY 2.5" of lift. However, if you are looking at a 2.5" coil lift (depending on brand) you can gets upwards of 3" of lift sometimes.

Now, when those factory springs start to sag on your budget boost, you will have even less of a lift than the advertised whereas a coil lift will be unlikely to sag less than it was advertised at.

I hope I made sense of that... in short, springs are better.

As far as shock adapters versus replacement shocks... that depends on what type of shocks you have right now. In general, if you are only looking at a 2" to 2.5" lift, and have a Rubicon with relatively low miles, then you factory shocks are fine for the time being and shock adapters will work just fine.

However, if not all of those things are true, then new shocks of an appropriate length for your lift is advisable.
03-23-2011 10:13 PM
Coils vs. spacers

I've searched the forum for answers to my lift questions, but what I've found comes up short.

What are the advantages to a suspension lift that replaces the springs over
just the spacers in a budget boost?

Secondly, same question for repalcing shocks as opposed to using the shock

I'm not overly concerned about the difference in costs, just the difference
in performance and functionality.


Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 03:22 PM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC