|03-29-2011 12:50 PM|
|IndyJeepMan||If you get creative and dish the cash out you can fit 33's stock|
|03-29-2011 12:32 PM|
|joesunlimited1||Thanks all for the input!!! Just to recap i should be able to fit the tire i have listed on stock Canyon wheels with lift I have listed. And a 1" bl would just be insurance?|
|03-29-2011 10:32 AM|
1. prevent suspension/steering/drivetrain interferences
2. prevent shocks from bottoming out
3. prevent coil bind
4. prevent tire/fender interferences
notice tire clearance issues are on the bottom of the list.
|03-29-2011 09:27 AM|
Yes, as well as saving your shocks, w/o bumpstops your shock could become the limiting factor with axle articulation. Bottoming out your shock with the weight of the axle/wheel can be a bad thing. The same goes with a full compression. I've finished a trail run with only three shocks due to a busted rear shock mount before. It was, um, interesting.
|03-29-2011 09:00 AM|
|03-29-2011 04:43 AM|
|joesunlimited1||The bump stops are just so you dont over compress your springs right?|
|03-28-2011 08:46 PM|
|03-28-2011 08:31 PM|
|Koda22||I have after market rims....forgot about that.....|
|03-28-2011 08:29 PM|
|03-28-2011 02:41 PM|
|Bone||I'm running 31s on my stock rims ('04 LJ) with no lift right now and I have plenty of room. With a 2" spacer lift I wouldn't go bigger than 32s on your stock rims with stock flares. You CAN fit 33s on it with different rims but the problem is that you'll shred your flares pulling into your driveway. You can run the Bushwacker flat style flares with 33s and lessen that problem but you still won't have enough room for much articulation with the 2"BB and 33s. Don't worry about the T-case drop on the LJ, that isn't an issue with that amount of lift.|
|03-28-2011 02:22 PM|
|KawiMonsterSahara||Not sure on the bumpstops... think he is stock... but dont know for sure..|
|03-28-2011 02:17 PM|
|03-28-2011 01:05 PM|
|03-28-2011 12:50 PM|
the 1" t-case spacer is not necessary on your LJ, and has no bearing on tire size.
|03-28-2011 11:53 AM|
|joesunlimited1||The lift I have is 2" spacers, 2" bumpstop extensions, 1" transfer case spacer and longer shocks. And extended quick disconnect swaybar links. Totally confused....|
|03-28-2011 11:33 AM|
to add bigger tires you need more lift and/or more bumpstop extension.
To fit 33s with the budget boost you'll need to add a 1" Body lift, 1-2" front bumpstop extension and 2" rear bumpstop extension.
|03-28-2011 04:59 AM|
|joesunlimited1||Koda Did you have to change your wheels? Are they something with a different back spacing?|
|03-27-2011 09:42 PM|
|Koda22||I got 33x11.50 on my jeep with a rough country 2.5inch lift.....and dont rub...|
|03-27-2011 07:55 PM|
|joesunlimited1||Thanks I think I understand.|
|03-27-2011 11:50 AM|
The generally recommended approach is a 2"-2.5" lift, 1' body lift, 1" motor mount lift, and maybe 1" extended bumptops--plus, adjust the steering stops.
With a 2"-2.5" lift on a TJ without a SYE/driveshaft/rear upper adjustable control arms, you most often have to add a transfer case drop to avoid rear driveshaft vibrations. A less expensive way to deal with this without having to lower your transfer case skid is to install a 1" motor mount lift and 1" body lift at the same time.
So yes, you can do it without the BL/MML if you add 2" extended bumpstops when you do the 2" BB with a 1/2"-1" transfer case drop. However, the BB, BL, MML is a better approach.
May 32s risk being too wide and rubbing the rear upper spring perches unless you run wheel spacers or a rear adjustable trackbar to center your axle.
|03-27-2011 11:38 AM|
Minimum for 33's
Can I fit 33x10.5x15's on stock Canyon wheels with bb or will I need to add body lift? Also am I correct in thinking that with 10.5 wide tires I won't need to change wheels with different bs? Or should I just go with 32's?