Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > xfer case oil pump question

Join Wrangler Forum Today


Thread: xfer case oil pump question Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-22-2006 09:34 PM
rich1014 And now that I think about it, the oil pickup tube is below transfer case fill plug. So the pump would work anyway - just wouldn't recirc the oil as efficiently.
04-22-2006 09:31 PM
rich1014 I just did the advanced adapters sye kit today - I have an 05 tj. No o-ring on mine either. I didn't even put silicon around it - just made sure it was in the oil pump hole when reinstalling the pump. I hope I don't burn the transfer case up. After my initial test drive (goodbye vibs!) I got under there and felt all around. The transfer case was hot, but I could hold my hand on it, so I think I'm ok.
04-20-2006 07:39 AM
ghogklr After some thinking about the purpose of the pump, I pulled the speedo gear back out and it was covered w/ fresh fluid, so fluid is getting pumped into the rear housing so it must be working.
04-19-2006 12:59 PM
ghogklr
xfer case oil pump question

Installed my SYE yesterday, and had both a page off Stu's and the Teraflex instructions to go by. Everything went well and it sure is a lot smoother now. My question is this: When I took everything apart, my oil tube going into the pump did NOT have an o-ring on it. The tube had a metal collar/flare type deal about 1/2" down from the end, and then the inside of the pump had a machined mating surface for it to sit on. Is this normal for an 05 to not have the o-ring? I put a small bead of ultra-black around the flare on the tube for good measure before I seated it back in, and it was a good snug fit. Anyone else find they had no o-ring? Is there any way to check to see that it's working right?

thanks

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 07:45 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC