Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > General Jeep Discussions > Communications and Electronics > after market amp

Join Wrangler Forum Today


Thread: after market amp Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
02-21-2013 11:08 AM
Anjunafan Seelye, I was wondering how that SA-8 ended up working for you? I was planning on doing the same thing. A SA-8V2 4ohm wired to a JL 500/1 amp in the stock enclosure with some polyfill in it
04-16-2011 05:40 AM
mml seelye, that sub is a beast! you say it doesn't "thump" do you think it's the plastic enclosure, if so what if you put dynomat or fiberglass to reinforce it....
i was thinking about the jl stealth as well, i imagine that you would have to replace the factory subwoofer/interior panel with the non-subwoofer version to add the jl, assuming all would fit.
another option (as seen somewhere...) is to install the sub in the cargo space in the floor....
04-15-2011 06:46 AM
seelye im not getting the "thump" that this sub can produce,but its much louder than the factory infinity...

i am actually going to sell a few car audio items i have and get the jl audio wrangler stealthbox..i will then remove the factory sub box and replace it with
Jeep Wrangler Stealthbox by JL Audio
04-15-2011 06:43 AM
seelye
04-15-2011 05:31 AM
mml seelye, any update of your system.
04-04-2011 09:00 PM
seelye i have a 2011 sahara unlimited and wired in an external amp after the factory one.i use a line level,i still have total control of my sub by using the amp adjust and it doesnt effect the factory sub at all.. its a kicker zx1000.1 and is mounted on the back side of the rear passenger seat.i just ordered a sundown audio sa-8 8" dual voice coil 2 ohm sub,,i am going to run my speaker cables from my kicker amp through the back of the factory enclosure and fabricate a ring for the factory enclosure because i think the sub i ordered is a bit deeper than the factory infinity,this will in turn skip the factory amp all together and i will have total control over the 500watt 8" in the factory enclosure, it might poke out a little bit further than the infinity but only about an inch,,so losing an inch to keep my trunk isnt bad,,im in the middle of moving and not sure how to upload from phone,but as soon as i figure it out i'll post some pics.

edit,,make sure your line level has a remote wire.
03-29-2011 08:51 PM
mml i have a nav unit with u connect, will the output quality be good, i've tried some of the real basic ones in the past (simple resistors) and they sound kind of crappy so i was thinking of trying a more expensive processor in hopes of getting good sound
03-29-2011 08:43 PM
Jma20a you can get line level converters to splice into a set of speakers that convert it to a set of rca cables
03-29-2011 08:25 PM
mml alpine has a processor the should do the trick.
i see other manufacturers offer similar devices.
03-29-2011 04:41 PM
Jaydogg25 generaly no stock radio has rca's. being that it's a newer vehicle probably have to spend some cash on a adapter. alot of newer vehicles can't use a line level converter (old way). you probably have a factory amplified system and speakers maybe crossed over already. and generaly when you do this if keeping stock radio dont be chocked if you have to replace all speakers and even re-wire them as well.

idk if jeeps do it but i know on chevy's they have door chime going through driver speaker and when u amp the speakers makes that real real loud and anoying
03-26-2011 03:45 PM
mml
after market amp

hey, i take delivery of a 2011 rubicon on tuesday, it has the nav with uconnect, does anyone know if there are rca outputs or some sort of line output that can connect to a better amp, speakers, and sub....

thx

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 03:40 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC