Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > Hella 500 Install HELP!!!!

Join Wrangler Forum Today


Thread: Hella 500 Install HELP!!!! Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-01-2011 05:16 PM
Richd1963 I figured that, although they did dim with the factory wiring. I just made the change yesterday and haven't tried it out yet to see if I eliminated the dimming. Also. I was more concerned if I up the wattage in the bulbs to like 100 watts. Thanks.
05-01-2011 05:12 PM
nu arty boy Hella 500s have 55w bulbs. The stock wiring will be perfectly fine.
05-01-2011 05:07 PM
Richd1963 The factory jeep lights have skimpy wiring. I don't believe it would be sufficient for higher wattage bulbs. The factory fog lights used to dim at low idle also. I am hoping that supplying power directly from the battery with a 12ga. wire will resolve the dimming issues and supply enough amperage to power up to 100 watt bulbs.
05-01-2011 03:50 PM
nu arty boy If you have factory fog lights just cut the wires going to your factory lights and solder the wires for the new lights to the factory wiring harness. Make sure that you heat shrink the connection so you don't get dirt or water in there.
05-01-2011 10:45 AM
Richd1963 My Hella's came with a wiring diagram. Although, I wired them in to be controlled by the factory fog light switch. I just installed a homemade harness and relay yesterday. I gave the Hella relay and harness to the guy who bought my factory Hella fog lights.
04-29-2011 10:08 PM
s3nt3nc3d Find a diagram and use it to help with the wiring...the directions are a joke...I understand basic electronics and schematics and their directions had me scratching my head.

Basically what you want to do... run a wire from the battery to the coil on the relay. On the other side of the coil, run a wire from it to the switch, then from the opposite side of the switch to a good ground point.

From there...run a wire from the hot lead of the lights to one side of the "switch" on the relay. Then from the other side of the switch, run a wire from there to the battery. Then ground each light separately to a nearby bolt (grind off any rust and get a good bare metal ground).

Instead of using the switch provided with my kit to power my lights, I tapped off my high beam wire...so whenever my high beams turn on, it kicks my Hella 500's on. The only drawback to this is that I can't run them with my low beams, but if there's any oncoming traffic, you can't run them anyway so I really don't miss out much.

I did keep my switch in there so I can turn the lights off separately...I just can ONLY turn them on with my highbeams.

I'm sure I didn't make that much easier for you to understand, but when you see a basic schematic, it's really quite simple.
04-29-2011 09:10 PM
BlueHoseJeep75
Hella 500 Install HELP!!!!

alright everyone, I just recently recieved some Hella 500 lights as a gift. I have never done anything like this before and do not even know where to start. Im even having a hard time reading the page of random lines. Can anyone "shed some light" on this topic. (bad joke i know) any type of help would be much appeciated.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 02:14 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC