Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > Tune up questions/suggestions?

Join Wrangler Forum Today


Thread: Tune up questions/suggestions? Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-30-2011 01:43 AM
DAMSTR8 If your sahara is 2000 or newer just use ngk, but anything older just get the old champion plugs. I as well as others learned the hard way with 1999 and older 4.0's. They run like crap and nothing will run for you any better than just plain ol' champions. Get the Champion truck plugs (4412) if available. They are great for the higher heat that the 4.0 is notorious for. Just stay away from all that overly hyped titanium stuff.
04-30-2011 01:39 AM
PTWarrior66 How much do garages charge for tube ups aside from oil changes. I probably could figure it all out but I'm 18 and figure I'll probably F up somewhere seeing as I already broke my battery. The garage here always has off road and 4x4 vehicles and the guy is pretty respected and trust worthy in our small town.
04-30-2011 01:30 AM
n00bkiller944 You will need a jack and jackstands to do the diffs... at least i did for my jeep
04-29-2011 09:52 PM
Jeep9706 Thanks for the responses everyone !

I have another question though, since I do not have jackstands or any way of lifting my jeep, will I still be able to successfully drain the fluids. I know I'll have enough room to get/work under there and everything, but will everything drain properly since it's not on a jackstand? Wish me luck !!
04-29-2011 08:21 PM
Nailhead432 First off, don't replace ur brake fluid unless u got a buddy or have done it b4. I don't want u to get air in ur brake system. Second, u don't have a pcv valve, u have a fixed orfice that doesn't need to be replaced. Get champion plugs, don't fall victim of snake oil spark plugs. Good wires and cap to go along with it would be nice as well. (can't go wrong with mopar). U can drain everything into one bucket, it just better be a big bucket. Good luck and if u got questions, just ask.
04-29-2011 08:18 PM
robbiecc ..
Quote:
Originally Posted by Jeep9706 View Post
Evening everyone,

so I will be doing my first tune up tomorrow using my owner's manual and haynes repair manual as guides. Please let me know if you have any suggestions. Also, this is my first time doing a tune up. Here's my plan:

Drain and replace following fluids: coolant, brake fluid, manual transmission fluid, transfer case fluid, power steering fluid. I will be purchasing the recommended fluids from the owners manual.
don't know as i'd do the power steering and brake fluids unless they look like they need it-i'd probably just check/fill as needed and save the brake fluid for when you do a brake job, as long as you're doing the coolant, think i'd back flush the heater core. may also want to do the front/rear dif and a grease job(mine only has 7 fittings-front suspension) also don't forget the engine oil/filter

Also, replace air filter, AC delco or Purolator.

PCV filter replacement. Any specific kind/brand to replace with?

Also will replace spark plugs.
toss in a cap/rotor and inspect the wires-replace if needed

Also plan on checking the hoses for wear and breaks but I think this is a good start for a Newb. What do you guys think? Any other suggestions on minor stuff to replace?
also check condition of belt(s) and tension of belts.

Also, I be will draining the fluids into an oil pan. Do I need a separate oil pan for each so as not to create a chemical reaction or am I thinking too much into this?
I will dump the fluids in a designated container/place at the local auto parts dealer afterwards. But do I need 6 diff. pans lol? Any other general suggestions or feedback would be great. Thanks so much !

when i know this job will be comming up, i start saving gal milk jugs for waste fluids-make too much of a mess trying to use qt containers.
04-29-2011 08:00 PM
TJChris27 After putting the new fluids into the jeep put the old fluids into those containers. Well that's what i do at least i never thought that far into with chemical reactions and whatnot lol. But sounds like you got pretty much everything covered! Just be wary sometimes the haynes manual leaves out things lol. But over all its alright.
04-29-2011 07:04 PM
Jeep9706
Tune up questions/suggestions?

Evening everyone,

so I will be doing my first tune up tomorrow using my owner's manual and haynes repair manual as guides. Please let me know if you have any suggestions. Also, this is my first time doing a tune up. Here's my plan:

Drain and replace following fluids: coolant, brake fluid, manual transmission fluid, transfer case fluid, power steering fluid. I will be purchasing the recommended fluids from the owners manual.

Also, replace air filter, AC delco or Purolator.

PCV filter replacement. Any specific kind/brand to replace with?

Also will replace spark plugs.

Also plan on checking the hoses for wear and breaks but I think this is a good start for a Newb. What do you guys think? Any other suggestions on minor stuff to replace?

Also, I be will draining the fluids into an oil pan. Do I need a separate oil pan for each so as not to create a chemical reaction or am I thinking too much into this?
I will dump the fluids in a designated container/place at the local auto parts dealer afterwards. But do I need 6 diff. pans lol? Any other general suggestions or feedback would be great. Thanks so much !

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 11:26 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC