|04-30-2011 06:15 PM|
|01WranglerGuy||Thanks to everyone for the help, its the 3.73 gear ratio.|
|04-30-2011 04:47 PM|
The front is a Dana30. If you have an open carrier in the rear all you have to do is
jack up 1 rear wheel
put the jeep in neutral and release the e-brake (make sure to chuck the other wheels so the jeep does not move)
make a mark in the driveshaft with anything you can see
rotate the wheel 1 revolution and count how many times the driveshaft rotates
times that number X 2 and that is your ratio.
|04-30-2011 03:52 PM|
|doclouie||Look at the tag on the left side of your front differential cover. (Front and rear gearing will be the same) It will say the gear ratio on the tag. Most likely 3.07 or 3.73. It is the small tag between the two bolts on the left hand side. Your front end is a dana 30 and the rear is a dana 44 as it has a metal drain plug.|
|04-30-2011 02:47 PM|
This site has always helped me out. I used this page everytime I need stock info on my TJ. Its on a another forum but its VERY informative. Hope it helps. Stock TJ Specifications - JeepForum.com
|04-30-2011 02:31 PM|
|04-30-2011 02:23 PM|
|98 wrangler||There sholda been a little metal tag attatched to a couple of diff. cover bolts with that info on it. if your jeep is a rubicon with factory gears thewill be 4.10|
|04-30-2011 02:03 PM|
D44 what gears?
I had read on an earlier thread that you can find out what gears you have by looking at the rear diff. Any clues??