Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > Leveling after winch install

Join Wrangler Forum Today


Thread: Leveling after winch install Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-01-2011 10:06 AM
JeepnJim Thank you folks. My 31" BFG ATs are new so I won't go to 33" for a while. My long term plans are to go OME but for now I'll go for spacers just to level things up a bit. I just thought while I was at it I would add a tad bit more lift. Sounds like we're all on the right track though. By the way, adding a winch is the best mod I've ever done to any of my Jeeps!
04-30-2011 09:23 PM
TheDirtyGeneral Although if you want to run 33" with maximum effectiveness I would suggest using at least 2.5" of lift and 1.25" BL I run OME but I would also suggest zone's combo kit as I've installed that one on a friends Jeep and it sits a little higher than mine with no other modifications needed. Also look into a motor mount lift instead of a transfer case drop
04-30-2011 06:51 PM
TheDirtyGeneral He wants a leveling kit with a small lift on a budget. He can get 1/4in spacers and 1 1/4 in spacers and use them accordingly. That plus a 1.25 in BL and you can run 33" with the appropriate bump stop extensions and bar pin eliminators to give the shocks that extra in he's going to need
04-30-2011 06:44 PM
UnlimitedLJ04 why add so tall of spacers? its not going to fix the problem - the root of the issue is increased weight, and the spring rate that doesn't work for the weight. get springs with increased spring rate & length. if you're on a budget, look at ZJ V8 front springs from a junkyard. Up-Country XJ springs might also work if you want a slightly softer rate. Plenty of those around the junkyards.
04-30-2011 06:40 PM
SilverTJMike I'd call rokmen or dpg and get a old mane emu, I have a OME from rokmen, winch and bumper on the front no need for spaces, nice and level.
04-30-2011 06:05 PM
G54 To run 33s I think you might be better off going with a 2" - 2 1/2" spring lift and then add 3/4" spacers on top of the springs in front to level it. That with your BL should give you just about enough flex room for 33s. You will need longer shocks. You may still have to trim the flares a bit if you disconnect the sway bar off road. You will also need to add bump stop front and rear which can be done with hockey pucks on the spring perches. About one half puck (1/2") in front and one and a half (1 1/2") in the rear is what I needed.
04-30-2011 05:51 PM
TheDirtyGeneral add the spacers and use bar pin eliminators for your shocks if you dont plan on replacing them! You now have DIY budget boost!
04-30-2011 05:42 PM
JeepnJim
Leveling after winch install

I recently added a winch and it pulled the front down a bit. I'm thinking about a leveling kit that includes 2 3/4 front spacers and 1 3/4 rear spacers with bumperstops. I'm guessing the front is about an inch lower so wouldn't this kit give me a level Jeep with about 1 3/4 total lift. I have a 1.25" BL and will eventually get some 33" tires. Any thoughts on this plan?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 04:21 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC