Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ Tech Forum > no oil pressure

Join Wrangler Forum Today


Thread: no oil pressure Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-04-2006 01:28 PM
97TJAC but i have the lifters ticking now

and i took an OP sending unit off another 4.0 Jeep and it did the same thing.. this was all before the ticking

the oil pumped looke fine...although some reason i was able to take it off with my fingers.. the bolts were loose and there was evidence of "blow by" on the gaskets


I am guessing this is the start of all my problems... bought the motor used at a junkyard and the damn pump wasnt on all the way
05-04-2006 12:24 PM
Jerry Bransford Early TJs, maybe late model TJs too but I am not sure, had bad oil pressure senders. They'd also often wait to send erroneous zero oil pressure signals until you were alone out in the boondocks near Midnight as happened to me!

Replacing mine completely stopped the multiple zero oil pressure indications, it's been ok the last 9 years.
05-04-2006 11:10 AM
calpher I have the exact opposite poroblem. My guage is always pegged until my Jeep warms up. Then it goes down a bit. I am 99 percent sure that it is the sending unit. I just haven't gotten around to replacing it yet!
05-04-2006 10:05 AM
paracutin You guys are talking about two different things here. Zero pressure vs low pressure.
Zero pressure is bad.

97TJAC,
What did the pump drive gear look like when you pulled it out? Was it badly worn, cracked, etc...?

my98tj,
My 2000TJ with 66k on it runs about 16lb of pressure at idle when fully warmed up. When the rpm's are 1500 or above I get 40 - 50lbs. It is my understanding that this is quite normal for the 4.0.
I have read that 10lb is the low limit so if you are at 10lb or above don't worry about it.
05-04-2006 09:08 AM
my98tj i would like to know what is happening with this because mine started doing the same thing the other day. it runs just fine, but the oil pressure drops considerably when i'm not up in the RPM's. when i'm at speed it's fine. i've checked the oil i don't know how many times and there's always oil in it. i think i'm gonna replace the oil pressure switch. i'll let you know if that works or not. any other help would be greatly appreciated.
05-04-2006 08:57 AM
calpher Wow! If you've done all that then I have no idea! Did you replace the oil pickup tube when you replaced the oil pump? I'm just throwing stuff out there. Sorry!
05-04-2006 08:32 AM
97TJAC I put on a manual oil pressure guage before I changed the oil pump and at idle it read like maybe 1 or 2 PSI
05-04-2006 07:36 AM
calpher I know this may sound kinda stupid...but have you thought about replacing the oil pressure sending unit?
05-04-2006 07:32 AM
97TJAC
no oil pressure

ok so this may be long

went to wellsville last weekend..
doing good following lil stock geo trackers and even a stock blazer
i go through the same holes they go through and what not
well one hole decided when i got out of it that it wanted to screw my oil pressure... as in the OP dropped to 0 when not hittn the gas

long story short.. changed oil 3 times that day
came home and today (wednesday) dropped oil pan.. it was perfetly clean..oil pump and screen CLEAN but i bought a new pump and put it on neways
filled it back full of oil...new filter
running GREEEEEEEEEAAAAAAAAT for bout 10-25 mins around 30psi
then all of a sudden the OP dropps to ZERO AGAIN!! and u can hear the lifter

now what the hell is the problem?
it is not smoking
it is not missing
the rods are not makn a noise
no leaks nothing

this is the 2nd time this has happened to me
last year i had this happen and we replaced motor

there was no sign of anything in the oil pan just oil

someone please help me

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 06:55 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC