Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > high oil presure but no oil top end help

Join Wrangler Forum Today


Thread: high oil presure but no oil top end help Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-14-2011 03:39 AM
hookuspookus who did the valve adjustment ? was it a high pressure pump ?did you let it pump up enuff ? start it and stop it a few times and see if it pumps up did you adjust the valves per spec ? did you spin the push rod while adjusting ? it should have a very slight drag on it , when you do get it to pump run it then re-adjust your valves . did you top dead zero the crank than set the valves that where supposed to be set at that position then turn the crank and adjust the other valves in order ? sounds like you didn't set the valves right and new lifters may take a few minutes to pump up . i don't have my book handy are the valves ajustable or are they valve train style ? i forget . how high is the pressure ? over 50 psi ?
05-13-2011 07:33 PM
amisonrh8
high oil presure but no oil top end help

Hi everyone I have a 2000 tj and I just got done rebuilding it by putting in a stoker kit. Now my 4.0 is a 4.6 but I have ran in to a problem i have now oil making it up to the top of the engine. I thought it was the new oil pump so I replaced it with another one. I primed the pump and watch oil come out of the rods but after starting the engine nothing, the oil pressure shows very high. Help please I am going crazy trying to figure this out.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 03:58 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC