|05-22-2011 09:15 PM|
|atomicjoe23||Thanks. . .I'm part way into the thread now. . .|
|05-22-2011 06:45 PM|
this should help
YJ-based, "go-fast" Juggy build - Pirate4x4.Com Bulletin Board
|05-22-2011 06:39 PM|
Really. . .mine is a YJ as well. . .
. . .I had this idea about 2 years ago and I'm just now getting around to acting on it.
I'll look for that thread.
|05-22-2011 06:24 PM|
|Irongrave||then wider is better I'd run it along with the TTB from an f150. there is a really good write up on Pirate with a guy that did a TTB on a YJ frame|
|05-22-2011 04:27 PM|
Off-centered pinion angle???
Is the pumpkin not centered on the F-150 8.8???
The bolt pattern isn't an issue because I'm putting a D44 TTB up front. . .I'm a desert-guy, so it's a high speed, long travel Jeep not a crawler Jeep. . .our 1949 Jeep Willy's pick-up truck is the solid axle crawler.
|05-21-2011 11:32 AM|
You can pretty much make any axle work with the right modifications. It will work. However, a F-150 8.8 is I believe 69" while the Explorer runs 60". So it will certainly stick out more. Not to mention, I believe the bolt pattern is 5x5.5 with drum brakes. You'll need to address the off-centered pinion angle.
All in all, you'll spend the same you'd spend on an Explorer axle right there. I'd skip it and keep looking.
|05-21-2011 11:16 AM|
Ford 8.8 rear axle swap. . .quick question?
I've got a line on a Ford 8.8 out of a 1996 2WD Ford F-150 for free. . .it already has an Auburn posi unit, 31 spline axles, 4,30 gears, 4-link tabs (still has leaf mounts on as well) and it has the speed sensor/tone ring too. . .
. . .I know the 8.8 out of an Explorer is supposed to work for the Wranglers, but will this axle work as well? I've got a '94 Jeep YJ Wrangler.