|05-26-2011 03:37 PM|
I've done the seal around the air intake. I've also done a seal around the motor on the engine side of the heater core.
This stopped a LOT of it.
If you reach up under your dash you'll feel a spongy gasket. if it is wet, that is likely one of your sources. RTV'ing like in the pic above took care of a lot of it.
I have also noticed that with aftermarket door skins (Bestop), I often end up with water between the Bestop upper and factory half door, so I'm sure some water is getting in that way as well. Haven't figured that one out yet...
Shelby, can you get a pic of the foam you're talking about below?
|05-26-2011 11:53 AM|
|05-26-2011 06:39 AM|
On our 97 it does serve as a water block. The right side vent, above the air intake is a solid piece, the rest are screened(?) to allow air in.
Without it, it's a straight shot from the cowl to the intake to the floor.
|05-25-2011 11:47 PM|
Plus it came from the factory with double sided tape, nothing special.
|05-25-2011 09:18 PM|
Something else, it the above fails. Little easier then pulling the HVAC case out.
Pull the blower motor out. You may be able to look in the case then and see what's up.
From memory, pull the battery out. You may/may not have to remove the PCM too.
But then you'll have access to the motor. Unplug it, some bolts and out it will come.
If you can't see in well, use a mirror/flashlight to see what up.
|05-25-2011 09:13 PM|
Give it one more shot. Take the shop vac, and jamb the nozzle onto the drain tube.
It might just yank out what's blocking the system.
|05-25-2011 08:48 PM|
|BMF machine||Ok, I'm a big dummy! Still leaking, I guess I'll have to start disassembling the dash, in the morning...|
|05-25-2011 03:51 PM|
|BMF machine||Ok, looking good....doesn't seam to be leaking into my floor board anymore!!!!yay! I got a good deal on this little jeep, the guy hemhawed around about how nice the carpet was, he said he never had the carpet in it. The floor board has been sprayed flat black recently to cover the surface rust. The big dummy, I wonder if he sold it cause he couldn't fix the leak? After I put some miles on it, I'll let ya know how it turned out. I had taken the cowl off at first(like a big dummy.) it was my first time at doing that and it was a pain, but fun......and I even found a use for the expired coat hanger.....lol I ROCK!|
|05-25-2011 03:04 PM|
|BMF machine||Ok, seams weird? There was plenty of water draining onto my floor, it just seamed to take a while before it was coming out of the case onto my floor. I was able to poke a coat hanger in there with out too much trouble? Not sure how clogged it was....hopefully the water will stop coming out on my floor now? I'll keep ya posted....|
|05-25-2011 02:53 PM|
|BMF machine||Thanks for fast replies! Got to feed kids then to work on jeep I go|
|05-25-2011 02:32 PM|
And yeah a blocked a/c drain will allow condensation/water to build up in the evaporator case, until it overflows into the blower housing, and leaks onto the floor.
And your a/c is working if you are using the defroster also, not just when you have the a/c turned on.
|05-25-2011 02:28 PM|
Umm, the a/c drain is part of the evaporator case. It has a tube that pokes out through the firewall, to allow condensation drain out. Look down below the battery, for a black tube about 3/4" in diameter sticking straight out of the fire wall.
Take a piece of coat hanger, bend a small hook on the end, CAREFULLY insert into the tube and see if you can catch what's blocking it up. I say careful as the evaporator is right behind that tube so you don't want to willy nilly poke in there or you could get a nasty surprise.
|05-25-2011 02:11 PM|
|BMF machine||Mine seams to be coming from the air conditioner? Any good pointers on how to find and replace the a/c drain?|
|05-24-2011 04:44 PM|
|BMF machine||Thanks guys! I have same problem, looked under the hood and can see where the gasket is rotten. Going out to fix it now.|
|05-22-2011 12:42 PM|
A floor mat with a molded hole that leads through the drain hole on the jeep. If any water accumulates on the mat, it will drain right out. Huh, huh?? Genus right?
|05-22-2011 11:23 AM|
A true Jeeper there.
Then again, there are times you don't want wet feet.
I just added deep walled floor mats to ours before I fixed the door.
Keeps all the crap and water trapped in them.
|05-22-2011 10:51 AM|
|kjeeper10||I know you probably don't want to hear this. my jeep leaks all over the place from the day I bought it 11 years ago. I see instances where newer jeeps are having issues also. I just keep the drain plugs out and call it a day|
|05-22-2011 08:16 AM|
I ended up posting what I did to fix it on a different thread. Here's my response as to what I did to make the fix.
I believe I figured out what was causing my leak as posted above. The plastic guard that is part of the cowl piece has separated from the metal. Thai allowed the water to flow down in to the fresh air vent and then on to the floor. Just today I used RTV sealant to affix the plastic guard back to the metal cowl. I'll let it dry overnight and then run a bead of silicone caulk along the length of th elastic piece to ensure a watertight seal. I believe this will work, wish me luck.
The plastic piece I'm referring to can be seen in the below photo.
Also you can see how the plastic piece separated from the metal cowl in the second photo, from a profile view.
I hope this helps you with your situation.
|05-21-2011 09:20 PM|
Not that bad of a fix. The seal deteriorates on the door, rain water sneaks past the plastic cover and the seal doesn't stop it. Drips into the housing and down on the floor.
Pull the wiper arms, and cowl off. Remove the cover for the door, look in the housing and most likely you' see a spot where the water has washed off the dust in there.
Clean off the old foam, you can pick up stuff that will work at Lowes or HomeDepot, etc.
It's the same stuff you use to seal up windows/doors with. Just find a matching width and thickness. Peel off the backing and stick it on, replicating the old foam.
Little dab of silicone where the ends touch.
Reinstall the cover. If you want to go a step further, run a bead of silicone around the cover edge. This way the water can't even get in there. It will run past and out the drains.
Don't skip the foam part. If you don't use it the door will rattle.
|05-21-2011 09:02 PM|
|Fnx14||JMc what did it end up being? I am having the same issues and have tried everything you did minus replacing that foam, i figured that foam might be difficult to get ahold of.|
|04-22-2011 05:33 AM|
That could make sense. I know there's a foam gasket that surrounds the fresh air deflector door. I could see if that was supposed to seal out the water I could see how that could fail. If you fin the write up I would sure like to read it; I'll look too. Thanks. N advance.
|04-22-2011 12:04 AM|
|Gamgan||Isn't this because if a foam seal that rots away behind the dash around the glove compartment area?? I know I saw a guide on it I'll look it up and post it here|
|04-21-2011 06:39 AM|
|JMc||Thanks Vans. It's definately water. When I pour a bottle of water in to the fresh air duct I see it come thru on to the floor.|
|04-19-2011 06:13 PM|
|vans661||Hey Only thing I can think of that would have fluid on your pass floor board is like your heater core... 2 lines going to it, could be your problem.... Also is it actually water? or coolant?|
|04-19-2011 11:46 AM|
Water on Passenger Floorboard
I know there have been several threads about Jeep's getting water on the passenger floorboards and there has been a lot of good suggestions. However, I've done all of the relevant suggested fixes and still end up with water. This only happens with the Jeep (TJ) in parked, not when it's being driven, so I've eliminated the A/C condensor drain tube as the cause. Here's what I've done thus far.
1.) I removed the cowl cover and cleaned out the cowl drain that's in the middle of the cowl area. Water easily drains thru this now.
2.) I applied RTV around the fresh air intake "scoop" and around the cowl drain.
3.) I sprayed the entire front half of the Jeep while monitoring the leak area. I found it's not coming from the hard top or soft top, it also not coming from the door, windshield or firewall area.
4.) The only way I could get the leak to happen on my own was to pour a bottle of water down the fresh air intake. When I did this the water collected on the floorboard just as it does when it rains.
So, my question is can anyone offer suggestions as to how to prevent this? Is water that gets into the fresh air intake supposed to drain somewhere (other than on to the floor)? If not, what other suggestions do you have to prevent water from getting in to the fresh air intake?
Thanks in advance.