|04-08-2012 01:53 PM|
Slick 50 makes a spray lube in a red can, the stuff is amazing, I use it on everything, hard to find, I have had my can for 8 years now, hope It never runs out. It has solved problems no other lubes have.
Copy on the WD 40. It's old school and does not lube, prevents rust
|04-08-2012 09:51 AM|
|04-08-2012 09:49 AM|
|04-08-2012 08:51 AM|
|lindel||Now that you've got the hole drilled, try white lithium grease as a lube.|
|04-08-2012 08:36 AM|
|TLATEOTW||This is where i drilled a hole, it worked great, the gate opens/closes smoothly now. It's on the inside so it doesn't show when the gate is closed|
|04-08-2012 02:28 AM|
|04-07-2012 06:40 PM|
|TLATEOTW||did the holes, put some oil in them, the gate is still a bit stiff but much better, will add more tomorrow and exercise with the gate some more|
|04-07-2012 11:17 AM|
|msrenner||i used the pb blaster lubricant. worked great. just have to use a lot.|
|04-07-2012 11:13 AM|
|20ga||YES! WD-40 is a solvent not a lubricant.|
|04-07-2012 10:48 AM|
You want to be using a penetrating oil at all the hinge gaps. Or, as you mentioned, drilling a small hole and forcing some oil/grease into it. Careful not to go too far in and mess up the pin though.
|04-07-2012 10:38 AM|
|InfernoGirl||PB blaster works wonders on mine......|
|04-07-2012 09:30 AM|
|GoldenSahara00||Spray alot. Mine swing too good now and I haven't lubed In a year.|
|04-07-2012 09:28 AM|
i'm having the same issue, i've been spraying wd-40 on them and swinging back and forth for an hour with no improvement.
It seems that it's not penetrating inside, i think i'll drill a 1 mm hole in the moving part of hinge and spray in it. hopefully this will work
|05-29-2011 10:54 PM|
|niwroc||I just sprayed some penetrating oil into them and worked them back and forth, and then sprayed them again, and kept working the tailgate back and forth. That freed them up quite nicely, and then to protect them a little from getting bad again too fast, I sprayed on some white lithium grease and worked it in a little. Took about 5 minutes and they swing like new!|
|05-29-2011 01:51 AM|
|05-29-2011 01:13 AM|
|rbloodhound||Every thong I have read says to replace then.|
|05-29-2011 01:12 AM|
|Peepers||I replaced the hinges on my 98. so worth it. just a little $$$... but swings like a million bucks... I tried greasing it every way i could think of and fit grease in there. there is a point where its just not saveable.|
|05-29-2011 12:56 AM|
A good way to lube tailgate hinges?
Is there any easy way to lubricate the tail gate hinges? I have a 98 that are sticking and making it hard to swing the tail gate.