Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > CJ Jeep Forum > CJ Tech Forum > High Beams??

Join Wrangler Forum Today


Thread: High Beams?? Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
08-26-2007 11:38 AM
MadPatter Dont mean to make ya feel old but my jeep is 6 years my senior lol and thanks again i am gonna call around and find one i hope
08-26-2007 06:08 AM
noise My I hope this thread is making someone other than me feel old.


Yes a foot switch is exactly what it says. Almost ALL cars had only foot switches 20 to 25 years ago.
It mounts on the floor next to your break pedal or clutch if you have one. You more less step on it to switch the brights on and off.
08-26-2007 02:09 AM
MadPatter On my dash i got my light switch its a pull out knob. One pull turns my lil blinker lights on, pull it the rest and it turns the light on. No carpet just bare metal so no wiring there. My blinker is attatched to the steering column but it just tilts up and down to turn the blinkers on.

So the light switch is not even connected to the steering column at all so it shouldnt be hard to put in a switch i wouldnt think??? Now when they say a foot witch does that mean u turn it on with your foot or is that wjust where the thing is wired to then it has something else that comes up?
08-25-2007 10:20 PM
penguin_in_a_cj to be honest you can get a floor switch pretty cheap and its ten times easier to wire it to the floor then to get into the steering colum.
08-25-2007 06:57 PM
skeeter What do you have for a turn signal switch?
The wiring is pretty simple but we need to find out what you have to start from.
Do you have carpet? if so look under the carpet for some wires that may have been cut off by your left foot.
if all else fails, try tracing the wires from switch to headlight. You should already be wired for high beams, just gotta figure out what and where the switch was.
08-25-2007 03:37 PM
MadPatter No good no switch there but there are 3 mounting holes to put in switches, always gotta find a plus i guess? So any ideas on how to put one in?
08-25-2007 03:20 PM
MadPatter Hmm gonna have to check, that would be so great if i did. I have to go buy a wiring repair kit and try and get all the gauges and heater in my jeep working before winter. So far all that works are exterior lights, wipers (not the pump tho), and the gas and speedometer. The rest nothing, not even inside lights so i drive by street light to see my speed and engine sound.
08-25-2007 03:11 PM
steveshra Do you have a button on the floor to the left of the clutch? I didn't know what mine was at first either, but if you have one that is the button for the brights. If it doesn't work, try cleaning out any junk from inside it.
08-25-2007 02:56 PM
MadPatter
High Beams??

Anyone know about adjusting the wiring of the lights so that i can install a switch to have high/low beams on the headlights of my 1980 CJ5?? I got new lights that say they are the rplacements for it and they have a high/low beam on it but my jeep just has a pull knob to turn them on or off no high setting

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 04:22 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC