|06-07-2011 07:44 PM|
|Jerry Bransford||I wouldn't bother or pay more for arms that can be adjusted with a center turnbuckle-like section. It just adds cost and the really good control arms are not made that way anyway. All you have to do is disconnect one end to adjust their length and then you normally only have to do it once unless you make a dramatic change to the rear end.|
|06-07-2011 07:38 PM|
Adjustable control arms
So, has anyone out there turned their stock arms into adjustable using a kit?
|06-07-2011 07:10 PM|
|Phil05LJ||^^^ That's a better explanation. Good point about the jam nuts, use Loctite thread locker on them.|
|06-07-2011 06:51 PM|
|06-07-2011 06:46 PM|
How did those lower replacement bushings you ordered work out?
|06-07-2011 05:33 PM|
Rokmen makes great arms.
Also check out Currie and Clayton Off-Road
|06-07-2011 05:22 PM|
|06-07-2011 05:18 PM|
Found these from a friend on JeepForum.com. It's nice to know that I am not that crazy:
Read product description:
Rokmen HD-Rear Upper Control Arms - Rokmen - Control Arms - Suspension
|06-07-2011 04:51 PM|
|idahonetto||It is my understanding that someone does in fact manufacture control arms that can be adjusted after installation - I just don't know who it is. Perhaps this unknown technology doesn't exist! Thanks!!!!|
|06-07-2011 04:43 PM|
You can adjust any control arms after installation. They all use inner threads so you have to spin the joint to increase or decrease length. I'd go with the Rokmen arms.
They way to adjust them is to jack the vehicle up, set the pinion angle and have the axle placed where it should be, then adjust the control arms till they are long or short enough then tighten down the jam nut then place them in the mount and bolt them in..
Nature of the beast, unless there is some unknown technology for adjustment while on the vehicle attached both ends..
|06-07-2011 04:26 PM|
After installation adjustable rear upper control arms
Looking to purchase adjustable rear upper control arms that can be adjusted AFTER installation. Any recommendations?